User manual BLACK & DECKER GK1740

[. . . ] Your Black & Decker chainsaw has been designed for pruning and felling trees and cutting logs. Failure to follo w all instructions listed below may result in electri c shock, fire and/or serious injury. The term "power tool" in all of the warnings listed below refers to your mains operated (corded) power tool or battery operated (cordless) power tool. Do not operate power tools in explosive atmospheres, such as in the presence of flam mable liquids, gases or dust. [. . . ] Follow the manufacturer's sharpening and maintenance instructions for the saw chain. Safety recommendations for the chainsaw We strongly recommend that first time users obtain practical instruction in the use of the chainsaw and protective equipment from an experienced user. Initial practice should be completed sawing logs on a saw horse or cradle. We recommend that when carrying the chainsaw that you make sure that the brake is engaged Maintain your chainsaw when not in use. Do not store your chainsaw for any length of time without first removing the saw chain and guide bar which should be kept immersed in oil. Store all parts of your chainsaw in a dry, secure place out of reach of children. Be sure of your footing and pre-plan a safe exit from a falling tree or branches. Use wedges to help control felling and prevent binding the guide bar and saw chain in the cut. Kickback can be caused by: Striking branches or other objects accidentally with a tip of the saw while the saw chain is moving. Striking metal, cement or any other hard material near the wood, or buried in the wood. We strongly recommend you do not attempt to operate your chainsaw while in a tree, on a ladder or on any other unstable surface. If you decide to do so, be advised that these positions are extremely dangerous. When cutting a branch that is under tension, be alert for spring back so that you will not be struck when the tension is released. Into small sized brush and saplings because slender material may catch the saw chain and be whipped towards you, or pull you off balance. Ensure someone is nearby (but at a safe distance) in case of an accident. If for any reason you have to touch the saw chain, make sure your chainsaw is disconnected from the mains. We therefore recommend you take appropriate measures for the protection of hearing. The following warning symbols are found on your tool: Read all of this manual carefully. Always remove the plug from the socket before inspecting a damaged cable. Electrical safety This tool is double insulated; therefore no earth wire is required. Always check that the power supply corresponds to the voltage on the rating plate. Additional safety instructions This appliance is not intended for use by young or infirm persons without supervision. [. . . ] Make a single horizontal felling cut from the other side 1-2 inches above the centre of the direction notch. Do not cut through to the direction notch, you could lose control of the direction of fall. Drive a wedge or wedges into the felling cut to open it and drop the tree (fig. Pruning trees Make sure that there are no local by-laws or regulations that would prohibit or control the pruning of the tree limbs. [. . . ]