User manual BLACK & DECKER GH1000

[. . . ] If the plug still does not fit, contact a qualified electrician to install the proper wall outlet. Do not change the equipment plug, extension cord receptacle, or extension cord plug in any way. Before any use, be sure everyone using this tool reads and understands all safety instructions and other information contained in this manual. ⷠSave these instructions and review frequently prior to use and in instructing others. [. . . ] ⷠDISCONNECT TOOL ­ when not in use, when replacing line, or prior to cleaning. Follow all instructions in this Instruction Manual for proper operation of your tool. Motors in these tools normally spark, and the sparks might ignite fumes. ⷠSTORE IDLE TOOLS INDOORS ­ When not in use, tools should be stored indoors in a dry, locked-up place out of reach of children. ⷠGROUND FAULT CIRCUIT INTERRUPTER (GFCI) protection should be provided on the circuits or outlets to be used for the gardening appliance. Receptacles are available having built in GFCI protection and may be used for this measure of protection. ⷠCHECK DAMAGED PARTS ­ Before further use of the appliance, a guard or other part that is damaged should be carefully checked to determine that it will operate properly and perform its intended function. Check for alignment of moving parts, binding of moving parts, breakage of parts, mounting, and any other condition that may affect its operation. A guard or other part that is damaged should be properly repaired or replaced by an authorized service center unless otherwise indicated elsewhere in this manual. WARNING: To prevent electrical shock hazard, use only with an extension cord suitable for outdoor use. Always connect extension cords to a fused line or one protected by a circuit breaker. To keep your line in top condition, store spare CAUTION: ALWAYS WEAR EYE PROTECTION CAUTION: Inspect area to be trimmed and remove any wire, cord, or string-like objects which could become entangled in the rotating line or spool. Be particularly careful to avoid any wire which might be bent outwardly into the path of the tool, such as barbs at the base of a chain link fence. ⷠWith the unit on, slowly swing the trimmer side to side as shown in Figure 5. ⷠTo convert for maintenance edging, unplug the unit from the power source. Return to the trimming position by unplugging the unit from the power source, pushing the button and rotating the tube back 180°. When using the tool put up the wire edge guide to the original position, out of the way. 080" (2mm) diameter, ROUND nylon line to cut grass and weeds quickly and easily. During use, the tips of the nylon lines will become frayed and worn and the special self feeding line hub will automatically feed and trim a fresh length of line. Cutting line will wear faster and require more feeding if the cutting or edging is done along sidewalks or other abrasive surfaces or heavier weeds are being cut. The advanced automatic line feeding mechanism senses when more cutting line is needed and feeds and trims the correct length of line whenever its required. DO NOT BUMP unit on ground in attempt to feed line or for any other purposes. [. . . ] Whether you need technical advice, repair, or genuine factory replacement parts, contact the Black & Decker location nearest you. WARNING: The use of any accessory not recommended by Black & Decker for use with this tool could be hazardous. IMPORTANT: To assure product SAFETY and RELIABILITY, repairs, maintenance and adjustment should be performed by authorized service centers or other qualified service organizations, always using identical replacement parts. NOTE: For best results, wind line onto the outer portion of the spool (side with arrows) first. [. . . ]