User manual BLACK & DECKER CST2000

[. . . ] Safety glasses are available at extra cost at your local Black & Decker Service Center or authorized service facility. ⷠDRESS PROPERLY ­ Do not wear loose clothing or jewelry. Rubber gloves and substantial rubber soled footwear are recommended when working outdoors. Don't operate the appliance when barefoot or wearing open sandals. [. . . ] Press the release tabs on the line spool cover, as shown in Figure 14 and remove the cover by pulling it straight off. ⷠLift the spool of nylon line out of the hub and clear any broken line or cutting debris from the spool area. ⷠIn case of jams and tangled line unwrap about one foot (30cm) of line to ensure that it is undamaged. If it is OK rewind it and insert the line end through the eyelet in the spool hub, as shown in Figure 15. Pull the line through the hole to maintain tension while placing the spool down into the hub with the notched side exposed, as shown in Figure 16. ⷠPress the spool down GENTLY and rotate it until you feel it drop into place. (When in place, the spool will turn a few degrees left and right freely. ) · Snap the hub cover back on, insert the battery and turn the tool on. In a few seconds or less you'll hear the nylon line being cut automatically to the proper length. 065" DIAMETER LINE) Bulk line for your trimmer/edger is available at extra cost from your local dealer or Black & Decker Service Center. Press the release tabs on the line spool cover, as shown in Figure 14 and remove the cover by pulling it straight off. ⷠRemove the spool from the tool and remove and discard all line on the spool. ⷠInsert one end of the bulk line into the hole in the spool shown in Figure 17 about 1/2" (12mm). ⷠHold the line in the hole and pull the rest of the line through the slot in the spool, shown in Figure 17. ⷠSnugly and evenly wind the bulk line onto the spool in the direction of the arrow on spool in Figure 17 until it is nearly full. ⷠInsert the line end through the eyelet in the spool hub, as shown in Figure 15. Pull the line through the hole to maintain tension while placing the spool down into the hub with the notched side exposed, as shown in Figure 16. ⷠPress the spool down GENTLY and rotate it until you feel it drop into place. (When in place, the spool will turn a few degrees left and right freely. ) · Snap the hub cover back on, insert the battery and turn the tool on. In a few seconds or less you'll hear the nylon line being cut automatically to the proper length. WARNING: When using electric tools, basic safety precautions should always be followed to reduce risk of fire, electric shock, and personal injury, including the following: Do not incinerate the battery even if it is severely damaged or is completely worn out. [. . . ] The defective product will be replaced or repaired at no charge in either of two ways: The first, which will result in exchanges only, is to return the product to the retailer from whom it was purchased (provided that the store is a participating retailer). Returns should be made within the time period of the retailer's policy for exchanges (usually 30 to 90 days after the sale). Please check with the retailer for their specific return policy regarding returns that are beyond the time set for exchanges. The second option is to take or send the product (prepaid) to a Black & Decker owned or authorized service center for repair or replacement at our option. [. . . ]