User manual BLACK & DECKER BV3600

[. . . ] DO NOT place inlet or outlet of vacuum near eyes or ears when operating. When not in use, the unit should be stored in a dry, high or locked-up place - out of reach of children. DO NOT pick up anything that is burning or smoking, such as cigarettes, matches or hot ashes. To assure product safety and reliability, repairs, maintenance, and adjustments should be performed by Black & Decker service centers or authorized service stations, always using Black & Decker replacement parts. [. . . ] A double insulated appliance is marked with the words double insulated or "double insulation". The symbol (square within a square) may also be marked on the appliance. To reduce the risk of electric shock, this equipment has a polarized plug (one blade is wider than the other). This equipment must be used with a suitable polarized 2 wire or 3 wire extension cord. Make sure that the receptacle end of the extension cord has large and small blade slot widths. If the plug does not fit fully into the extension cord, reverse the plug. If the extension cord does not fit fully into the outlet, contact a qualified electrician to install the proper outlet. WARNING: Before attempting any of the assembly steps below, ensure product is switched off and disconnected from the power supply. NOTE: Unit will not operate in blow mode without grill cover in place. â· Blow tubes must be assembled to the power head before use. â· Never operate without both lower and upper tubes assembled. â· In the interest of safety, it is not intended for the tubes to be separated once assembled. â· Push the lower tube firmly into the upper tube, until the tubes click into place. Push the tube assembly onto the power head until it is in the fully locked position (figure 2). Use the air concentrator attachment to target air flow to a tighter area. Attach the shoulder collection bag to the power head as shown in figure 4. Push the lower tube firmly into the upper tube, until the triangles click into place. In the interest of safety, it is not intended for the tubes to be separated once assembled. Remove the fan cover from the bottom of the power head by pressing the spring loaded release button (located on the back of the power head) and pulling the cover off (figure 6). Attach the vacuum tube assembly to the power head (figure 7) by locating the assembly as indicated by arrow, then pivot about this point until the locking/release catch is fully engaged. To remove the blow tube, vac tube or shoulder collection bag, depress the release button on the power head and pull straight off 8 (figure 6 & 8). Do not use in vacuum mode without the vacuum tubes and collection bag in place. [. . . ] (If the product repeatedly causes the circuit fuse to blow, discontinue use immediately and have it serviced at a Black & Decker service center or authorized servicer. (If the product repeatedly causes the circuit breaker to trip, discontinue use immediately and have it serviced at a Black & Decker service center or authorized servicer. Com for the location of the service center nearest you or call the BLACK & DECKER help line at 1-800-544-6986. Recommended accessories for use with your tiller are available from your local dealer or authorized service center. [. . . ]