User manual BLACK & DECKER BH35EK

[. . . ] 12 Avoid unintentional starting Do not carry the plugged-in tool with a finger on the switch. 14 Disconnect tool Shut off power and wait for the tool to come to a complete standstill before leaving it unattended. Unplug the tool when not in use, before servicing or changing accessories. 15 Remove adjusting keys and wrenches Always check that adjusting keys and wrenches are removed from the tool before operating the tool. [. . . ] 1 2 3 4 5 6 Variable speed switch Tool holder for SDS-plus® accessories Mode selector with safety lock Side handle Depth adjustment rod Depth stop clamp Torque limiting clutch All rotary hammer drills are equipped with a torque limiting clutch that reduces the maximum torque reaction transmitted to the operator in case of jamming of a drill bit. This feature also prevents the gearing and electric motor from stalling. the torque limiting clutch has been factory-set and cannot be adjusted. Variable speed The variable speed feature allows speed to build up slowly, thus preventing the drill bit from walking off the intended hole position when starting. Always check that the power supply corresponds to the voltage on the rating plate. Your Elu tool is double insulated in accordance with EN 50144; therefore no earth wire is required. Check for damage to the tool, parts or accessories which may have occurred during transport. Take the time to thoroughly read and understand this manual prior to operation. Should your mains plug need replacing and you are competent to do this, proceed as instructed below. If you are in doubt, contact an Elu authorized repair agent or a qualified electrician. Cut off the plug and dispose of it safely; a plug with bared copper conductors is dangerous if engaged in a live socket outlet. Only fit 13 Amperes BS1363A approved plugs fitted with the correctly rated fuse (1). The cable wire colours, or a letter, will be marked at the connection points of most good quality plugs. Your Elu heavy duty rotary hammer drill BH35EK has been designed for professional rotary drilling and hammer drilling as well as light chipping, chiselling and demolition applications and for carbide-tipped core drilling. Before replacing the top cover of the mains plug ensure that the cable restraint (3) is holding the outer sheath of the cable firmly and that the two leads are correctly fixed at the terminal screws. B) The rotary hammer drill can be used in three operating modes: Rotary drilling: for drilling into metal, wood and plastics Hammer drilling: simultaneous rotating and impacting for concrete and masonry drilling and carbide-tipped core drilling Hammering only with spindle lock: impacting only - for light chipping and chiselling Bit rotation: non-working position used only to rotate a flat chisel into the desired position. Select the required operating mode by depressing the safety lock (8) and rotating the mode selector (3) towards the symbol on the housing until the safety lock clicks into position. Turn the bit slightly whilst depressing the accessory, until it clicks into position. The hammering function requires the bit to be able to move axially several centimetres when locked in the tool holder. To remove an accessory, pull back the tool holder locking sleeve (9) and pull out the bit. Never connect the live (L) or neutral (N) wires to the earth pin marked E or . For 115 V units with a power rating exceeding 1500 W, we recommend to fit a plug to BS4343 standard. [. . . ] Accessories and attachments used must be regularly lubricated around the SDS-plus® fitment. If your Elu product becomes defective due to faulty materials or workmanship within 12 months from the date of purchase, we guarantee to replace all defective parts free of charge or, at our discretion, replace the unit free of charge provided that: · Cleaning Keep the ventilation slots clear and regularly clean the housing with a soft cloth. Unwanted tools and the environment Take your tool to an Elu authorized repair agent where it will be disposed of in an environmentally safe way. However, if the Power Tool needs repair, please contact your dealer or the Elu Head Office for the address of the nearest Elu authorized repair agent (please refer to the back of this manual). [. . . ]