User manual BLACK & DECKER BEHTS501

[. . . ] Eu BEHTS301 BEHTS401 BEHTS451 BEHTS501 10 A 10 11 B 7 C D 5 4 E 2 F (Original instructions) ENGLISH G H 8 9 1 I Intended use J Your BLACK+DECKERTM BEHTS301, BEHTS401, BEHTS451, BEHTS501 hedgetrimmers have been designed for trimming hedges, shrubs and brambles. Failure to follow the warnings and instructions listed below may result in electric shock, fire and/or serious injury. The term "power tool" in the warnings refers to your mains operated (corded) power tool or battery operated (cordless) power tool. A wrench or a key left attached to a rotating part of the power tool may result in personal injury. [. . . ] U Health hazards caused by breathing dust developed when using your tool (example:- working with wood, especially oak, beech and MDF. ) Vibration The declared vibration emission values stated in the technical data and the declaration of conformity have been measured in accordance with a standard test method provided by EN 60745 and may be used for comparing one tool with another. The declared vibration emission value may also be used in a preliminary assessment of exposure. The vibration emission value during actual use of the power tool can differ from the declared value depending on the ways in which the tool is used. When assessing vibration exposure to determine safety measures required by 2002/44/EC to protect persons regularly using power tools in employment, an estimation of vibration exposure should consider, the actual conditions of use and the way the tool is used, including taking account of all parts of the operating cycle such as the times when the tool is switched off and when it is running idle in addition to the trigger time. Labels on tool The following pictograms are shown on the tool along with the date code: Warning!To reduce the risk of injury, the user must read the instruction manual. 5 ENGLISH (Original instructions) Remove guard retaining screw 10 with a Phillips screwdriver (not supplied). U Insert the guard retaining screw 10 into the opening on the side of the guard and tighten securely as shown in Fig. The use of the hedge trimmer without the proper guard or handle provided may result in serious personal injury. Immediately disconnect the cable from the mains if it is damaged or cut. Electrical safety This tool is double insulated; therefore no earth wire is required. Always check that the power supply corresponds to the voltage on the rating plate. If the supply cord is damaged, it must be replaced by the manufacturer or an authorised BLACK+DECKER Service Centre in order to avoid a hazard. U When using the tool outdoors, only use extension cables intended for outdoor use. A suitable rated BLACK+DECKER extension cable of up to 30 m can be used without loss of power. U Electric safety can be further improved by using a highsensitivity 30 mA residual current device (RCD). U A cord retainer (7) is incorporated into the rear of the switch handle (6). U Near the end of the extension cord, fold the extension cord to create a loop. U Hook the loop onto the cord retainer 7 so it rests in the cord retainer. D) Always hold the trimmer, as shown in the illustrations in this manual, with one hand on the switch handle and one hand on the auxiliary handle (Fig. Features Switching on and off This tool includes some or all of the following features. [. . . ] 65 cm mm s mm kg Level of sound pressure according to EN 60745: Sound pressure level at operator position (LpA) 89 dB(A), uncertainty (K) 3. Technical data BEHTS301 Type 1 Voltage Power input Blade strokes (no load) Blade length Blade gap Blade brake time Saw blade Max cut Weight VAC W min-1 cm mm s mm kg 230 500 1850 50 22 <1 35 2. 65 BEHTS301, BEHTS401, BEHTS451, BEHTS501 – Hedge Trimmer Black & Decker declares that these products described under "technical data" are in compliance with: 2006/42/EC, EN 60745-1:2009 +A11:2010, EN 60745-2-15:2009 +A1:2010 2000/14/EC, Hedge trimmer, Annex V Measured sound power level (LwA) 98 dB(A) Uncertainty (K) 2, 0 dB(A) Guaranteed sound power (LwA) 100 dB(A) These products also comply with Directive 2014/30/EU and 2011/65/EU. For more information, please contact Black & Decker at the following address or refer to the back of the manual. [. . . ]