User manual BLACK & DECKER ASI500

[. . . ] ) Do not incinerate the battery even if it is severely damaged or is completely worn out. ) If any leakage of liquid from the battery cells occurs, discontinue use immediately and return the battery to your local Black & Decker Service Center or authorized service facility. If the plastic housing of the battery breaks or cracks, immediately discontinue use and do not recharge. ) Since the vibration produced by the inflator may cause it to "walk", do not operate on a high shelf or other surface. [. . . ] Your Black & Decker inflation station is designed to be used cordless or in most vehicles from the standard 12 Volt socket to inflate car and bike tires, balls, rafts, air mattresses, swimming pool floats, etc. CHARGING THE BATTERY - FIGURE A A The internal battery must be recharged for 4 to 5 hours using the AC charger provided (13). â· Insert the jack plug (9) into the socket on the front of the unit (11). â· When fully charged, remove the AC charger from the power source and remove the jack plug from the unit. Wrap the 12v dc cord (17) around the base of the unit and snap the 12 Vdc adapter (8) into its storage location on the base of the unit (16). The air hose (5) is located in a storage channel around the top of the unit (fig. C), make sure the hose is snapped into the retaining clips and the lever is in the up position (fig. The pump hose (7) is stored around the center of the unit and snaps into position at both ends. FITTING THE ACCESSORIES - FIGURES D, E, F & G Your inflator is supplied with the standard tapered nozzles and 19 D the needle inflator nozzle, these are located on the front of the unit. â· To use the universal valve adaptor, make sure that the lever is 6 in the up position. Note: Always make sure that the lever is in the up position when not in use. Operate your inflator only with the universal valve adaptor or with the included nozzles. Note: Make sure that the universal valve adapter is firmly locked in place before turning the inflator on. To use the high volume adaptor (24), remove it from the high volume inflate connection. Many inflatables have an internal flap that prevents air loss during inflation, especially air mattresses. Unless this flap is displaced by the nozzle the inflatable will not inflate. Push the nozzle firmly into the valve to make sure that you push this flap out of the way. Excessive air pressure may cause a hazardous risk of bursting or personal injury. Check the manufacturer's maximum pressure rating for items being inflated. Note: If the pressure rating for the item being inflated is above 100 psi, note that the maximum run time is 10 minutes, leave to rest for 20 minutes before re-use. WARNING: Do not operate the inflator when the car 20 engine is running. On some vehicles the accessory socket may only become live a c b when the ignition key is in the accessory position. [. . . ] The defective product will be replaced or repaired at no charge in either of two ways. The first, which will result in exchanges only, is to return the product to the retailer from whom it was purchased (provided that the store is a participating retailer). Returns should be made within the time period of the retailers policy for exchanges (usually 30 to 90 days after the sale). Please check with the retailer for their specific return policy regarding returns that are beyond the time set for exchanges. [. . . ]