User manual BELLO WAVS325 ASSEMBLY

[. . . ] BE CAREFUL WHEN MOVING THE ASSEMBLED FURNITURE AFTER THE SHELVES AND DOORS HAVE BEEN INSTALLED, AND/OR WHEN THERE IS EQUIPMENT LOCATED ON OR IN THE FURNITURE AS THIS MAY CAUSE THE SHELVES AND OTHER ITEMS TO BECOME UNSECURED AND FALL. WHEN IN USE, THIS FURNITURE MUST BE PLACED ON A FLAT, SOLID AND LEVEL SURFACE. DO NOT PLACE ITEMS ON THE SHELVES WHICH EXCEED THE MAXIMUM WEIGHT LIMITS OF 200 LBS. FOR EACH LOWER SHELF HARDWARE LIST PART DESCRIPTION QUANTITY 1. [. . . ] CAREFULLY ALIGN the cam lock pins and dowel with the pre-drilled holes in the outer right side edge of the upper shelf (A) and SECURE them together by turning the cam locks to tighten. Alignment may require some slight movement of the parts to get the proper fit. Fig. SCREW one shelf support post (4) into both the front and rear center interior legs of the right cabinet side panel as shown in Fig. PLACE the center adjustable shelf (E) into the cabinet and lean it against the shelf support posts (4). Fig. REPEAT the same assembly procedure steps as described above for the opposite cabinet side panel (C) as shown in Fig. INSERT three cam locks (2) into the upper inside of each cabinet side panel (B) & (C) as shown in Fig. SCREW six cam lock pins (1) into the underside of the cabinet top (F) as shown in Fig. CAREFULLY ALIGN the cam lock pins in the cabinet top (F) with the pre-drilled holes in the upper edges of each cabinet side panels (B) & (C) and SECURE them together by turning the cam locks to tighten. Alignment may require some slight movement of the parts to get the proper fit. Fig. NOTE: AN OPTIONAL FLAT PANEL MOUNTING SYSTEM, PP-59B (black) and PP-59S (silver) are available from your Bell'O dealer. CAREFULLY ALIGN the door hinges (5) with the pre-drilled holes on the interior of each door (G) & (H), and SECURE them each with two screws (6) as shown in Fig. Once the cabinet is fully assembled, if needed, you can ALIGN the doors by adjusting the screws on the insides of each hinge using a screw driver as shown. Fig. This cabinet comes with 2 sets of door panel inserts (solid wood or glass) that can be used. To interchange the door panels, LOOSEN the clips that are used to secure the panel inside the door frame. POSITION the clips over the panel and TIGHTEN WHILE BEING CAREFUL NOT TO OVERTIGHTEN THE CLIPS. Thank You For Purchasing The Bell'O WAVS-325 Real Wood Audio Video Cabinet. This Cabinet Is Compatible With The Bell'O PP-59 OPTIONAL FLAT PANEL TELEVISION MOUNTING SYSTEM This heavy duty flat panel TV mounting system is designed to hang a Plasma or LCD TV up to 63" or up to 250 lbs. Made of heavy duty, scratch resistant, powder-coated steel, it includes a universal mounting bracket and most common hardware needed for TV mounting. CMS® Cable Management System is included to hide wires and interconnect cables. [. . . ] There are no warranties, express or implied, including without limitation merchantability or fitness for particular use, except as (i) contained herein or (ii) required by applicable law in the state whose law governs (which shall be New Jersey absent controlling law imposing the law of another state in lieu thereof as governing law). All warranties of whatsoever derivation shall be limited to the term set forth above, unless otherwise required by applicable law. ORAL OR OTHER WRITTEN STATEMENTS DO NOT CONSTITUTE WARRANTIES, shall not be relied upon by Buyer, and are not a part of the contract for sale or this limited warranty. Except as provided herein, Bell'O International shall have no liability or responsibility to the purchaser or any other person or entity with respect to any liability, loss or damage caused directly or indirectly by use of the product, including, but not limited to, any incidental or consequential damages. [. . . ]