User manual BELLO AVSC2123 ASSEMBLY

[. . . ] AVSC-2123 Audio Video System ASSEMBLY INSTRUCTIONS PATENT PENDING FOR YOUR SAFETY, PLEASE FOLLOW THESE PRECAUTIONS: !ALWAYS REMOVE THE TV AND OTHER EQUIPMENT FROM THE FURNITURE PRIOR TO MOVING THE ASSEMBLED UNIT. BE CAREFUL WHEN MOVING THE ASSEMBLED FURNITURE AFTER THE SHELVES AND DOORS HAVE BEEN INSTALLED, AND/OR WHEN THERE IS EQUIPMENT LOCATED ON OR IN THE FURNITURE AS THIS MAY CAUSE THE SHELVES AND OTHER ITEMS TO BECOME UNSECURED AND FALL. [. . . ] TILT the unit back up into an upright position, and ATTACH the Top Shelf Support (A) as shown. SECURE the Top Shelf Support to the Left and Right Front Frame Supports using two 50mm Bolts for each support. SECURE to the Cable Management System® with four 10mm Frame Screws using the Allen Wrench. Once all parts are correctly fastened together, go back and TIGHTEN all screws completely. Fig. TILT frame assembly onto its back and APPLY the four Plastic End Caps (3) to the ends of each Left and Right Front Frame Supports (C & D). APPLY two Glass Pads onto the Plastic End Caps located at the tops of the Left and Right Front Frame Supports as indicated in illustration above. With the help of a second person, MOVE assembled frame to the location of its intended use. Fig. PLACE the Top Glass Shelf (F) onto the assembled frame, making sure the curved edge of the Glass Shelf faces the front of the unit, and that the two silver disks used to secure the shelf fit into the holes at the top of the Cable Management System® (E). SECURE the Top Glass Shelf to the unit using two 13mm Top Shelf Screws (7), with the supplied Allen Wrench (9), as indicated in Fig. PLACE the three Lower Glass Shelves (G) into the frame assembly, making sure each fits securely into the shelf slots on the Left and Right Front Frame Supports, and into the slots in the Cable Management System®. SECURE each Lower Glass Shelf into place by applying four Plastic Shelf Screws (6) from the underside of each slot on the Left and Right Front Frame Supports, and TIGHTEN using the supplied Screwdriver Tool (8). From the rear of the Cable Management System®, , APPLY the three Shelf Lock Pins (5) to back of the the Lower Glass Shelves to further secure the shelves. Warranty One (1) Year Limited Warranty All Bell'O International products are warranted, with the exception of glass, to the original purchaser at the time of purchase and for a period of one (1) year thereafter. Glass is warranted to the original purchaser at the time of purchase and for a period of thirty (30) days thereafter. In order to provide you with timely assistance, please thoroughly inspect your furniture for missing or defective parts immediately after opening the carton. To receive replacement or missing part(s) under this warranty, go to our website at www. bello. com or call our Customer Service Department at 1-888-235-7646. Replacement part(s) will be shipped to you at no charge with Bell'O International assuming all shipping and handling expense. [. . . ] Except as provided herein, Bell'O International shall have no liability or responsibility to the purchaser or any other person or entity with respect to any liability, loss or damage caused directly or indirectly by use of the product, including, but not limited to, any incidental or consequential damages. Some states do not allow limitation on how long an implied warranty can last or the exclusion of limitation of incidental or consequential damages, so the above limitation and exclusion may not apply to you. You may also have other rights, which vary from state to state. BELL'O INTERNATIONAL CORPORATION, 711 Ginesi Drive, Morganville, NJ 07751-1235 Phone: (732) 972-1333 Fax: (732) 536-6482 Web: www. bello. com E-mail: sales@bello. com [. . . ]