User manual BEKO TZDA524

[. . . ] Congratulations on your choice of a service for many years. quality Appliance which has been designed to give you WARNING !DO NOT connect your appliance to the electricity supply until all packing and transit protectors have been removed. · Leave to stand for at least 4 hours before switching on to allow compressor oil to settle if transported horizontally. · If you are discarding an old refrigerator with a lock or latch fitted to the door, disable the lock/latch, ensure that it is left in a safe condition to prevent the entrapment of young children. [. . . ] When you rotate the knob, it displays the new setting for 5 seconds and then reverts back to actual temperature. IMPORTANT : When you press the fast freeze button (4), there may be a short delay before the compressor starts to operate. - E1 flashes on display (6) if there is a defrost sensor failure. 4 5 6 2 1 3 5 6 STARTING Final Check Before you start using the freezer check that: 1. Clean the interior as recommended under "CLEANING AND CARE. " Insert the plug into the wall socket and switch on the electricity supply. Green light will glow and the compressor will start running in about five minutes. The liquid and gases sealed within the refrigeration system may also give rise to noise, whether the compressor is running or not which is quite normal. If you are going to store frozen food open the freezer door and check that the fast-freeze button is off (the amber light will not come on). When temperature reaches -18 °C or below, you can put in your frozen food. If you are going to freeze fresh food, you must press the fast-freeze button. The amber light will come on and you must wait at least three hours before putting in your fresh food to be frozen. We recommend that you set the thermostat knob at MIN setting and monitor the temperature to ensure the appliance maintains desired storage temperatures (See Temperature Control and Adjustment section). TEMPERATURE CONTROL AND ADJUSTMENT Operating temperatures are controlled by the electronic thermostat knob and may be set at any position between MIN and MAX (The coldest position). The normal storage temperature of your appliance should be -18 °C (0 °F). Lower temperatures may be obtained by adjusting the thermostat knob towards MAX position. If temperature fluctuates after you put in food, don't worry, it is not a fault. When fast freeze button is on -27 °C will flash for 5 seconds on display. For hygiene reasons, always wrap food using a suitable packaging material before storing in your appliance to avoid contact with the appliance surface. Compartments other than the 1 fast freeze compartment shown with (1) should only be used for storage of frozen food shown 2 with (5, 6 and 7). Ice bank (3) has been specially designed to 4 make and store ice cubes (See Making Ice Cubes). Indicator light lens Fast freeze compartment Ice bank Drawers Adjustable front feets Ice cube tray 4 4 MAKING ICE CUBES Fill the ice-cube tray 3/4 full with water and place it on the special Ice Bank. The defrost water drains into a plastic reservoir at the back of the appliance and evaporates automatically. Ensure that the reservoir is fixed properly above the compressor. Reservoir 4 5 6 9 10 CLEANING AND CARE ** We recommend that you switch off the freezer at the socket outlet and pull out the mains plug before cleaning. ** Never use any sharp abrasive instrument, soap, household cleaner, detergent and wax polish for cleaning. [. . . ] Wait for at least 4 hours to allow the system to settle before switching on. Once the correct storage temperatures have been reached in the appliance, put back all the food. 2 1 5 3 6 4 45 ° 8 7 9 16 13 180° 12 15 16 8. 1819- 20212223- 14 11 10 13 14 GUARANTEE DETAILS Your new Beko product is guaranteed against the cost of breakdown repairs for twelve months from the date of the original purchase. · Repairs necessary as a result of faulty materials, defective components or manufacturing defect. [. . . ]