User manual BEKO TSE 1240

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual BEKO TSE 1240. We hope that this BEKO TSE 1240 user guide will be useful to you.


BEKO TSE 1240 : Download the complete user guide (940 Ko)

Manual abstract: user guide BEKO TSE 1240

Detailed instructions for use are in the User's Guide.

[. . . ] â· Leave to stand upright for at least 4 hours before switching on to allow the system to settle if transported horizontally. â· This appliance must only be used for its intended purpose, i. We do not recommend use of this appliance in an unheated, cold room e. On delivery, check to make sure that the product is not damaged and that all the parts and accessories are in perfect condition. [. . . ] Are 4 screws(2 pieces at the back, 2 pieces below the front edge) that should be removed. Cut the part shown in the picture and then remove it by the help of pliers. â· Place you appliance under the counter and adjust the front feets until its top touches to the counter. In order to use the product under the counter, the distance between the wall and the reference indicated in the top connection plastic must be minimum 595 mm. Fix the appliance under the counter by using 2 of the screws that was removed from the top cover. â· Check whether the power type and voltage your region corresponds to the one stated on the rating label inside the appliance. â· The electrical safety of the appliance is only assured when the grounding system in the house is installed in accordance with regulations. â· When placing the appliance, do not let the power cable get stuck under it; otherwise the cable will be damaged. The electrical specifications of your appliance is given on the rating label located inside the appliance. â· Route power cable to allow easy connection and disconnection after installation. â· A contact separator should be used if the power cable is not accessible. the frozen food compartment is suitable for the storage of pre-frozen food. The recommendation for storage, as stated on the food packaging, should be observed at all times. Excessive build-up of ice will affect the freezing performance of your device. It is therefore recommended that you defrost your appliance at least twice a year, or whenever the ice build-up exceeds 7 mm. Wrap the deepfrozen food in several layers of paper, or a blanket, and keep it in a cold place. ) from the appliance and use a suitable container to collect the thawing water. Use a sponge or a soft cloth to remove thawing water if necessary at the freezing compartment and frozen food compartment Keep the door open during defrosting. For quicker defrosting, place containers with warm water inside the appliance. never use electrical devices , defrosting sprays or pointed or sharp-edged objects such as knives or forks to remove the ice. After the defrosting is done, clean the inside (see the section "Cleaning and Care"). Place the frozen food into the drawers and slide the drawers into the freezer. [. . . ] Replacement light bulb can easily be obtained from a good local electrical or DIY store. Crisper or Drawers: To clean a drawer, pull it out as far as possible, tilt it upwards and then pull it out completely. Attention Always unplug the power cable or switch off the circuit breaker before cleaning. Be careful to prevent water from getting into contact with the electrical connections of the temperature control or the interior light. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE BEKO TSE 1240




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual BEKO TSE 1240 will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.