User manual BEKO RSA413

[. . . ] G) This appliance is not intended for use by young children or infirm persons without supervision H) Young children should be supervised to ensure they do not play with the appliance I) There shall be adequate ventilation of the room when the rangehood is used at the same time as appliances burning gas or other fuels L) There is a risk of fire if cleaning is not carried out in accordance with the instructions This appliance conforms to the European Directive EC/2002/96, INSTALLATION INSTRUCTIONS Assembly and electrical connections must be carried out by specialised personnel. · Electrical Connection The appliance has been manufactured as a class II, therefore no earth cable is necessary. The connection to the mains is carried out as follows: BROWN = L line BLUE = N neutral If not provided, connect a plug for the electrical load indicated on the description label. Where a plug is provided, the cooker hood must be installed in order that the plug is easily accessible. [. . . ] · The minimum distance between the support surfaces of the cooking pots on the cooker top and the lowest part of the cooker hood must be at least 65 cm. If a connection tube composed of two parts is used, the upper part must be placed outside the lower part. Do not connect the cooker hood exhaust to the same conductor used to circulate hot air or for evacuating fumes from other appliances generated by other than an electrical source. Before proceeding with the assembly operations, remove the anti-grease filter(s) (Fig. 6) so that the unit is easier to handle. - In the case of assembly of the appliance in the suction version prepare the hole for evacuation of the air. · We recommend the use of an air exhaust tube which has the same diameter as the air exhaust outlet hole. If a pipe with a smaller diameter is used, the efficiency of the product may be reduced and its operation may become noisier. · Warning: if the bulbs are not working, ensure that they are screwed in fully. · Installation Prior to proceeding with the assembly operations (according to the model that you have purchased), to facilitate handling of the device, remove the grille as indicated in Fig. · The appliance is equipped with 2 air outlets, to be used in accordance with your specific requirements: one is located on the upper part of the appliance and the other at the rear (Fig. -6- 1A). The flange D, to which the air exhaust pipe is connected, and a plug B, used to shut off the unused air outlet, are both supplied with the product. · FILTER REMOVAL WARNING - ENSURE THE APPLIANCE IS SWITCHED OFF AT THE MAINS BEFORE REPLACING THE BULBS AND FILTERS. remove the filters by lifting the recessed handle and lift free from the hood frame. To reinstall the filters position in the recess at the rear and press to lock in position. Replacement bulbs can be easily obtained from a good electrical or DIY store. BEFORE CALLING SERVICE/TROUBLE SHOOTING The hood was switched on but the unit does not operate. · Have you plugged in/switched on the power supply at the socket?Extraction is poor · Check and clean the filters if required, if required, if active filters are present replacement filters maybe required. THE MANUFACTURER DECLINES ALL RESPONSIBILITY FOR EVENTUAL DAMAGES CAUSED BY BREACHING THE ABOVE WARNINGS. USE AND MAINTENANCE · It is recommended to operate the appliance prior to cooking. It is recommended to leave the appliance in operation for 15 minutes after cooking is terminated in order to completely eliminate cooking vapours and odours. The proper function of the cooker hood is conditioned by the regularity of the maintenance operations, in particular, the active carbon filter. · The anti-grease filters capture the grease particles suspended in the air, and are therefore subject to clogging according to the frequency of the use of the appliance. [. . . ] · The anti-grease filters capture the grease particles suspended in the air, and are therefore subject to clogging according to the frequency of the use of the appliance. In order to prevent fire hazard, it is recommendable to clean the filter at a maximum of 2 months by carrying out the following -7- Guarantee and Service Your Beko product is guaranteed against the cost of breackdown repairs for twelve months from the date of the original purchase. What is covered? · All repairs necessary as a result of faulty materials, defective components or manufacturing defect. · The labour costs of a Beko approved repairer to carry out the repair What is not covered? · Transit or delivery damage · Accidental damage · Misuse, or abuse. · Cabinet or appearance parts, including knobs and flaps · Accessory items, including ice trays, scrapers, cutlery baskets · Repairs required as a result of unauthorised repairs or inexpert installation that fails to meet the requirements contained in the user instruction book. [. . . ]