User manual BEKO MC112

[. . . ] This NO FROST combi you have just purchased is our newest achievement in the range of products. It has a new and nice design, and is built according to the European and national standards which guarantee its operation and safety features. Moreover, the used refrigerant, R600a, is not polluting and does not endanger the ozone layer. Your new appliance is equipped with a system of forced direction of the cold air into the compartments and with an electronic system for the operation - control - adjustment - signalling and temperature display . [. . . ] This appliance was designed to operate and provide the design parameters (specified in the user instructions and on the rating label) in a range of ambient temperatures between +10 and +32 degrees C (50 and 90 degrees F). At ambient temperatures which are lower or higher than the lowest respectively the upper limit, disturbances can occur in the good operation of the appliance. At ambient temperatures below the lowest limit of 10 0 C, the farther we are from it (towards 0 0 C) the break time is bigger and bigger and the temperature increases in the freezer compartment. Before plugging in the appliance, please make sure that the parameters of the electric network in your house (voltage, current type, frequency) comply with the operation parameters of the appliance. The information concerning the supply voltage and the absorbed power are specified on the rating label placed inside, on the lateral side, which is visible after pulling out the crisper. The manufacturer has no responsibility for any damages related to persons, animals or destruction of goods, caused by the non-observance of the specified conditions. ⷠThe appliance is endowed with a supply cord and a plug (European type, marked 10/16A) with double earthing contact. If the plug is not the same type with the socket, please ask a specialised technician to change it. ⷠIt is advisable not to plug in the appliance to the mains by means of an extension piece or adapter. If necessary, assemble a longer supply cord but having the same features with the one supplied with the product. ⷠIf the appliance is located between two pieces of furniture, please make sure that they are not placed on the supply cord or press it. In order to obtain a temperature which represents exactly the temperature in that area , the temperature must be read after a few hours of stabilizing, for instance in the morning when the door is opened the first time. Fast freeze function It is used to freeze food in a short time or to make ice cubes. When the fast freeze button is pushed, a short beep is heard, confirming the function is active, and the orange light comes on. On the freezer display, the freezing target value will blink for 5 seconds, (-250C). During fast freeze, the temperature in the refrigerator compartment does never get below 00C, avoiding the freezing of food in this compartment. The cancelling of the function is performed by pushing once again the fast freeze button (1) or automatic after 12 hours . Do not introduce into the freezer a too big quantity of food at a time. The quality of food is best kept if it is frozen deeply as quick as possible. This is why it is better not to exceed the freezing capacity of the appliance specified in the "Appliance data sheet". To reduce the freezing time, you can use the function , , fast freeze". ⷠFresh food must not come into contact with the food already frozen. [. . . ] During this operation, please take care not to distort the tubes or pull out the cables. After finishing the cleaning, put the accessories back in their places and plug the appliance in. Red alarm light comes on On the display will appear messages like: E0, E1, E3, E4 or E8 ­ a service engineer will need to be called. Until the remedy of the error by the Service, you can continue the use the appliance, without the risk of alteration of the food. [. . . ]