User manual BEKO HSA 29530

[. . . ] Make your old appliance useless : - disconnect the appliance from the supply; - remove the supply cord (cut it); - remove the eventual locks on the door to avoid the blocking of children inside, while playing, and the endangering of their lives. The refrigerating apliances contain insulating materials and refrigerants which require a proper recycling. There is the risk of suffocation with parts of corrugated cardboard and with plastic film. In order to get to you in good condition, the appliance was protected with a suitable packing. [. . . ] If the socket is not the same type with the plug, please ask a specialised electrician to change it. This appliance was designed to operate at an ambient temperature between +100C and +430C (SN-T class). If the ambient temperature is above +430C, inside the appliance the temperature can increase. Placing it in a warm room, the direct exposure to sunbeams or near a heat source (heaters, cookers, ovens), will increase the energy consumption and shorten the product life. 100 cm from the cookers working with coal or oil; · Ensure the free circulation of the air around the appliance, by observing the distances shown in Item 2. Place the appliance in a perfectly even, dry and well ventilated place. The switching off must be possible by taking the plug out of the socket or by means of a mains two-poles switch placed before the socket. The achieved temperatures can vary according to the conditions of use of the appliance, such as: place of the appliance, ambient temperature, frequency of door opening, extent of filling with food of the freezer. The position of the thermostat knob will change according to these factors. Green LED ­ shows that the appliance is supplied with electric energy. Red LED ­ damage ­ lights if the temperature in the freezer is too high. The LED will operate 15-45 minutes after the putting into operation of the freezer, then it must go off. If the LED goes on during the operation, this means that defects have occurred. Orange button­ fast freeze ­ by pushing it the orange led goes on, showing that the appliance entered into the "fast freeze" mode . The exit of this mode is done by pushing the button again, and the orange led goes off. The three LEDs give information about the mode of operation of the freezer. Before putting into operation, clean the inside of the appliance (see chapter , , Cleaning"). After finishing this operation please plug in the appliance, adjust the thermostat knob to an average position. Leave the appliance work for about 2 hours without putting food inside it. Advice for food conservation The freezer is intended to keep the frozen food for a long time, as well as to freeze fresh food. [. . . ] ⷠWash the inside with lukewarm water where you add some neutral detergent. Do not use soap, detergent, gasoline or acetone which can leave a strong odour. During this operation, avoid the excess of water, in order to prevent its entrance into the thermal insulation of the appliance, which would cause unpleasant odours. Do not forget to clean also the door gasket especially the bellow ribs, by means of a clean cloth. [. . . ]