User manual BEKO FG944

[. . . ] In case these are not followed, personal injury or material damage may occur. This is the period for keeping the spare parts required for the unit to operate as described. general security · It is advised to contact with authorised service regarding learning the information and information places while upon requesting for disposing of/discarding the product. ⷠConsult the authorized service for all kinds of questions and problems about your unit. [. . . ] It is not appropriate for outdoor use even when it is covered with a roof. It is dangerous in terms of electric safety to expose the product to rain, snow, sun or wind. Warning: The electrical plug should never be inserted to the power socket during installation. A Your product is equipped with a natural cooling system (R600a) which does not contain CFC and HFC gases. Therefore, pay attention to not damaging the cooling system and piping during usage and transportation. In the event of damage, do not dispose the product in fire; keep your product away from potential fire sources that can cause the product catch a fire and ventilate the room in which the unit is placed. Things to be done for energy saving C Do not leave the doors of your refrigerator open for long periods. C Do not overfill your refrigerator so that it blocks interior air current. C Do not place your refrigerator under direct sunlight or near heat generating appliances like ovens, dishwashers, or radiators. Company cannot be held responsible when the instructions in the manual are not followed. The power socket; if there is any undesired power blockout, note the warnings in the "Solution Suggestions for Problems" section. Before disposing your machine, cut out the electric plug and, if there are any locks on the door, make them unoperatable not to expose children to any danger. The interior temperature of your refrigerator changes for the following reasons; · seasonal temperatures , · Frequent opening of the door and leaving the door open for long periods, · Foods put into the refrigerator without decreasing the temperature to room temperature. Exposing to sunlight) You may adjust the varying interior temperature using the thermostate. if the ambient temperature is higher than 32°C , switch the thermostate button to maximum position. It is normal when ice particles form on the back wall during the operation. Water formed after defrost flows into the evaporation container via the drain pipe through the water collecting chute, and here it evaporates automatically. ⷠCheck periodically whether the evaporation pipe is clogged and unclog it using the stick in the hole if necessary. LED indicators in the front section of your refrigerator are intended to help you in monitoring the operation of your appliance. Keep your food in the refrigerator in a safe manner by monitoring and using these LEDs and controls as explained below: Quick Cool Button (1): Used to cool the food quickly. Compressor may not operate immediately but after some time when the button is pressed and this is quite normal. Thermostat Setting Button (2): Used to set your refrigerator between minimum and maximum values. [. . . ] Decrease the time when the door remains open, use the door less frequently. The compressor protecting thermic is blown when there is sudden power blockout or when the plug is pulled out and inserted again, as the gas pressure is not balanced yet. If your refrigerator does not start to operate after this period, call the service. The plug of the refrigerator may be inserted recently or new food may be put into the unit. [. . . ]