User manual BEKO DE3762F

[. . . ] Do not connect your appliance to the electricity supply until all packing and transit protectors have been removed. Leave to stand for at least 4 hours before switching on, to allow compressor oil to settle, if transported horizontally. If you are discarding an old appliance with a lock or latch fitted to the door, ensure that it is left in a safe condition to prevent the entrapment of children. Your appliance contains non CFC substances in the insulation which are flammable. [. . . ] Remember you must take your reading very quickly since the thermometer temperature will rise very rapidly after you remove it from the freezer. Please remember each time the door is opened cold air escapes and the internal temperature rises. Therefore never leave the door open and ensure it is closed immediately after food is put in or removed. The recommendation for storage as stated on the food packaging should be observed at all times. Dairy products should be stored in the special compartment provided in the door liner. Fresh fruit and vegetables should be cleaned and stored in the crispers. Do not allow to come into contact with cooked food, to avoid contamination. For maximum efficiency, the removable shelves should not be covered with paper or other materials to allow free circulation of cool air. The plug has been inserted into the wall socket and the electricity is switched on. The liquid and gases sealed within the refrigeration system may also make some (noise), whether the compressor is running or not. Slight undulation of the top of the cabinet is quite normal due to the manufacturing process used; it is not a defect. Use luke warm water to clean the cabinet of the appliance and wipe it dry. Use a damp cloth wrung out in a solution of one teaspoon of bicarbonate of soda to one pint of water to clean the interior and wipe it dry. If the appliance is not going to be used for a long period of time, switch it off, remove all food, clean it and leave the door ajar. Door exterior, cabinet sides) with a silicone wax (car polish) to protect the high quality paint finish. Any dust that gathers on the condenser, which is located at the back of the appliance, should be removed once a year with a vacuum cleaner. Check door seals regularly to ensure they areclean and free from food particles. Clean the appliance with unsuitable material; eg petroleum based products. Subject it to high temperatures in any way, · To remove the dairy cover, first lift the cover up by about an inch and pull it off from the side where there is an opening on the cover. To remove a door tray, remove all the contents and then simply push the door tray upwards from the base. Make sure that the special plastic container at the back of the appliance which collects defrost water is clean at all times. If you want to remove the tray to clean it, follow the instructions below: · Switch off at the socket outlet and pull out the mains plug · Gently uncrimp the stud on the compressor, using a pair of pliers, so that the tray can be removed · Clean and wipe it dry · reassemble , reversing the sequence and operations 13. [. . . ] It is recommended to use thermal insulated bags to transport the food home. We recommend the thawing of the packets taken out from the freezer compartment be done in the refrigerator compartment. For this purpose, the packet which is going to be thawed will be placed in a vessel so that the water resulting from the thawing does not leak in the refrigerator compartment. We recommend you to start the thawing at least 24 hours before the use of the frozen food. [. . . ]