User manual BEKO 21231ND/S

[. . . ] ⷠThe space in the room where the appliance is installed must not be smaller than 10 cubic metres. Your appliance contains non CFC substances in the insulation which are flammable. ⷠPlease contact your local authority in your region for information on disposal methods and facilities available. Warning - Keep ventilation openings on the appliance enclosure or in the built-in structure, clear of obstruction. [. . . ] At lower temperatures the appliance may not operate, resulting in a reduction in the storage life of the food. ⷠThe climate class rate of your appliance is given on the rating label located inside the appliance. ) Cookers or other heat sources must not be placed above the counter where the appliance is installed under the counter. ⷠThe mains wall socket plug must be close to the right or left hand side of the appliance. There are 4 screws(2 pieces at the back, 2 pieces below the front edge) that should be removed. Cut the part shown in the picture and then remove it by the help of pliers. ⷠPlace you appliance under the counter and adjust the front feets until its top touches to the counter. In order to use the product under the counter, the distance between the wall and the reference indicated in the top connection plastic must be minimum 595 mm. Fix the appliance under the counter by using 2 of the screws that was removed from the top cover. ⷠCheck whether the power type and voltage in your region corresponds to the one stated on the rating label inside the appliance. ⷠThe electrical safety of the appliance is only assured when the grounding system in the house is installed in accordance with regulations. Attention Do not store explosive substances or containers with flammable propellant gases (canned cream, spray cans etc. If the bulb works, replace the light cover by inserting the rear lug and pushing up to locate the front two lugs. 4- If the light still fails to work, switch off the circuit breaker or unplug the power cable. Replacement light bulb can easily be obtained from a good local electrical or DIY store. Crisper or Drawers: To clean a drawer, pull it out as far as possible, tilt it upwards and then pull it out completely. Attention Always unplug the power cable or switch off the circuit breaker before cleaning. Be careful to prevent water from getting into contact with the electrical connections of the temperature control or the interior light. If the appliance is not going to be used for a long period of time, unplug the power cable remove all food. To preserve the appearance of your appliance, you can polish the exterior and the door accessories with a silicone wax. Clean the condenser at the back of the appliance once a year using a brush or a vacuum cleaner. ⷠAlways pack or wrap food, or put it in a suitable container, before storing it in the appliance. [. . . ] These noises can still be heard for a short period of time after the compressor shuts off. ⷠSudden, sharp cracking or popping noises are caused by the expansion and contraction of the inside walls or some components inside the cabinets. These noises are slightly louder at the start-up of the compressor and reduce when the appliance reaches the operating temperatures. also to avoid disturbing vibrations and noises make sure that; · Your refrigerator is standing level on all four feet. [. . . ]