User manual BABY LOCK IMAGINE

[. . . ] "IMPORTANT SAFETY INSTRUCTIONS" When using overlock machine, basic safety precautions should always be followed, including the following. "Read all instructions before using this overlock machine. " DANGER- To reduce the risk of electric shock. Always unplug this overlock machine from the electrical outlet immediately after using and before cleaning. Replace bulb with same type rated 15 watts/110 volts in 110V/120V area. [. . . ] The smaller numbers, 3. 0 and 5. 0mm, apply when the right needle is in use. It also moves the stitch fingers further apart or closer together for complete fabric support with any stitch width. A The stitch width is variable by the placement of Right and Left needles and the stitch width dial positions. (Fig. B) B 16 Differential Feed Your Baby Lock serger is equipped with differential feed. The set of feed dogs work independently in order to ensure smooth sewing on all fabrics (fig. A) When the differential feed adjusting lever, located at the machine's right, front edge is set on "N" for normal feeding, the feed dogs move the same distance. When the dial is set above "N", the front feed dog will feed more fabrics than the back. This is because the front feed dog moves at a greater distance than the back feed dogs. As a result, the fabric becomes compressed or eased, as the diagram on the front cover indicates. This action can eliminate wavy seams in stretchy fabrics or those cut on the bias grain. C), the differential feed can gather a lightweight fabric to nearly double fullness (fig. The front feed dog is actually feeding in twice as much fabric as the back feed dog is feeding out. To maximize the gathering effects, use the longest stitch length setting. This adjustment stretches the fabric slightly as it is sewn pulling it taught as it enters the needle. F), add more stretch to swim wear, active wear, and can be used to create a lettuce edge (see page 36). A B M A C H I N E S E T T I N G S D C F E 17 M A C H I N E S E T T I N G S Disengaging the Upper Cutting Blade When no trimming is desired, as when stitching on a fold, flip the cutting blade lock switch clockwise to the LOCK position. The cutting blade no longer moves up and down, but remains in its lowered position. To re-engage the cutting blade, turn the cutting blade lock switch half of a turn counter-clockwise. The blade will start moving automatically when you start sewing. Presser Foot Pressure Adjustment The presser foot pressure has been preset at the factory and rarely needs adjustment. You may find it necessary, however, to decrease the pressure for thick fabrics or increase pressure for thin fabrics to feed more smoothly under the foot. To decrease pressure, turn the screw counterclockwise. Snap-On Presser Foot The Imagine has the convenience of a snap-on presser foot. Push the presser foot release lever located at the back of the presser foot holder. Slide the presser foot to the rear to remove. Presser Foot Release Button Seam Line Guides To Replace: 1. Insert the tape or ribbon, into the slot in the front of the foot, then under the sole of the foot. (see page 41 for more instruction) The raised markings on the toe of the foot are seam line guides. [. . . ] If machine needs to be oiled, check with your nearest Baby Lock retailer for use of high grade recommended sewing machine oil. Turn your handwheel until the upper looper is in the far right position. With your right hand, first raise the needle plate in front of the blade. Finally, position the needle plate so that the needles lower in the center of each hole on the needle plate (fig. B). M A I T E N A N C E A B Replacing Light Bulb 1. [. . . ]