User manual BABY LOCK COVER STITCH V2

[. . . ] "IMPORTANT SAFETY INSTRUCTIONS" When using overlock machine, basic safety precautions should always be followed, including the following. Read all instructions before using this overlock machine. DANGER To reduce the risk of electric shock. 1. Always unplug this overlock machine from the electrical outlet immediately after using and before cleaning. Replace bulb with same type rated 15 watts/110 volts in 110V/120V area. [. . . ] Slip the thread into the telescopic antenna thread guide directly above the thread spool. Bring thread down from the telescopic antenna, snap thread into the orange thread guide on the top of the machine, and then down into the orange hole above the tension dial. Bring the thread down the right side of the orange tension dial, under the dial and back up the left side, making sure the thread is in the tension disk. Bring the thread through thread guide at top of machine and down to the pretension thread guide above the needle. Pass the thread from the left side behind the pretension thread guide plate on needle clamp and into thread guide above the needle. With the needle threader or tweezers in the accessory compartment, thread needle in the left "C1" needle position. Raise presser foot and place the thread on the second from the left spool pin. Slip the thread into the telescopic antenna thread guide directly above the thread spool. Bring thread down from the telescopic antenna, snap thread into the yellow thread guide on the top of the machine, and then down into the yellow hole above the tension dial. Bring the thread down the right side of the yellow tension dial, under the dial and the thread guide below the dial. Bring the thread through thread guide at top of machine and down to the pretension thread guide above the needle. Pass the thread from the right side behind the pretension thread guide plate on needle clamp and into thread guide above the needle. With the needle threader or tweezers in the accessory compartment, thread needle in the center "C2" needle position. Slip the thread into the tele scopic antenna thread guide directly above the thread spool. Bring thread down from the telescopic antenna, snap thread into the green thread guide on the top of the machine, and then down into the green hole above the tension dial. Bring the thread down the right side of the green tension dial, under the green dial and under the thread guide located below the yellow tension dial. Bring the thread through thread guide at top of machine and down to the pretension thread guide above the needle. Pass the thread from the right side behind the pretension thread guide plate on needle clamp and into thread guide above the needle. With the needle threader or tweezers in the accessory compartment, thread needle in the right "C 3" needle position. NOTE: After threading the needles, the thread is then place to the left and top of the presser foot. T H R E A D I N G 15 T H R E A D I N G How To Use The Needle Threader 1. Push the needle threader against needle and slide down the groove of the needle to the eye. With a point of the needle threader or the tweezers pull the loop of thread from the back of the needle, under the foot and to the back left. A B Front Cover Seam Guide There are marks on the bed of the Baby Lock that can be used as a guide while sewing. [. . . ] A)The chain/cover stitch needles are on the front portion of the needle clamp and are identified by C1, C2 and C3. C1Left chain/cover stitch needle can be used for chain stitch, left narrow cover stitch, wide cover stitch or triple cover stitch. C2Center chain/cover stitch needle can be used for a chain stitch, left narrow cover stitch, right narrow cover stitch or triple cover stitch. C3Right chain/cover stitch needle can be used for a chain stitch, right narrow cover stitch, wide cover stitch, or triple cover stitch. [. . . ]