User manual AUDISON VR 404

[. . . ] 6) If the PC used for the update is not the PC where the previous software version has been installed, before proceeding you first need to install the software and drivers you can find in the CD supplied with the Bit One product (following the document "Driver_Software_Installation_Guide_ENG. pdf", available on http://update. audison. eu). Then you will have to uninstall the software following the procedure hereafter. PC Software Update 1. Write down ALL the settings selected in the Bit One (Eqs, Delays, Filters, Output levels, Input configuration, Output configuration) or save them selecting "Save Setup" from the "File" menu. [. . . ] Write down ALL the settings selected in the Bit One (Eqs, Delays, Filters, Output levels, Input configuration, Output configuration) or save them selecting "Save Setup" from the "File" menu. By saving the settings of your Bit One through the "Save Setup" function you can view the settings in Offline mode: this software version does not allow you to automatically resume the settings you previously set. Uninstall the old version of the Bit One software: click "Start", "Control Panel", "Add or Remove Programs". Browse the listed installed programs and look for "bit one", select it and then click on "Remove". REMARK: In order to install the program on Windows 2000 / XP / Vista operating systems, the user profile must have Local Administrator privileges. If the user profile does not have these privileges, uninstalling the old software version and installing the new one will not be possible. 3. Create a new folder (named for example: bitone 1. 5. 0. 0) on the Desktop or wherever you prefer. Download the zipped folder "Bit_One_Update_PCsoftware_V1-5_Firmware_V1-5-0-0. zip"from http://update. audison. eu and save it in the folder you have just created. 02 2/4 5. Select the file previously saved during the download process, and click on "Open". Click on "OK". 5 6. 6 7. Now the new firmware will start being transferred to the Bit One: this is the only delicate phase of the procedure. When the update process is almost at the end, while the Flash memory is actually being written, the green progressing bar will stop for two to five minutes: this is normal, do not turn the Bit One off and do not exit the program. 7 8. A popup dialog box showing the message "Firmware update completed" will confirm that the firmware update procedure has been successfully completed: click on "OK". 8 9. Exit the Bit One Management Software and cycle power to the Bit One. 10. If the Bit One Firmware update has been successfully completed, the top right side of the window will display the following information: - the new Bit One Firmware version (V. REMARK: If the DRC Firmware version is not displayed or it is older than V. Now you have to reset all the Bit One settings, because its Flash memory map is not compliant with the new firmware. Select "Restore Factory Defaults" from the "File" drop-down menu. A warning popup dialog box will now appear asking you to confirm the reset process, click on "YES". [. . . ] Now you have to reset all the Bit One settings, because its Flash memory map is not compliant with the new firmware. Select "Restore Factory Defaults" from the "File" drop-down menu. A warning popup dialog box will now appear asking you to confirm the reset process, click on "YES". [. . . ]