User manual AUDISON BIT ONE

[. . . ] 2) First you need to update the Bit One PC software, then proceed with updating the Bit One firmware. 4) The firmware update should be attentively performed, following the warnings listed in the Bit One firmware update section of this document, to avoid damaging the product. [. . . ] Install the new Bit One software version by double-clicking the "setup. exe" file. Please follow the Install Wizard: it is exactly the same procedure as the one used to install the older version. rev. 02 1/4 Firmware Update REMARK: The firmware update procedure requires particular attention. So, it must be performed under the best possible conditions: if the firmware update is launched but prematurely interrupted (for example because the PC locks up or the USB accidentally disconnects during the firmware update), you need to contact our Customer Service for further support as memory programming may be necessary. Attention The first action to be taken is to create a new folder (named for example: bitone 1. 5. 0. 0) and save it on your desktop or wherever you prefer. Open the zipped folder "Bit_One_ Update_PCsoftware_V15_Firmware_V1-5-0-0. zip" using the specific software (for example Winzip or "Compressed folders" Windows utility if available in your PC), and save the files you can find inside the zipped folder you have just created. After double-checking that the above instructions have been followed, connect the Bit One to the PC. Select "Rescue Mode" and double click on the Bit One image. 3 If the update is being performed using a laptop, you have to connect it to the PC through the mains supply and not through the laptop battery. Close any currently running program before launching the firmware update procedure. Make sure that the Bit One is supplied in a continuous and stable way, at least during firmware update: check if the power supply and the remote in connections are correctly working, and if power is suppled in a continuous and stable way. Connect the Bit One to the PC using the USB cable supplied with the product. Make sure you save the Bit One settings by either writing them down or saving them selecting "Save Setup" from the "File" menu. 2. [. . . ] If necessary, reload the settings of filters, delays and EQs that you previously wrote down, or open in Offline mode the Setup you previously saved in your PC. Attention: the Setup you previously saved in your PC is not compatible with the new firmware version you just loaded. 14 16. [. . . ]