User manual AUDIOVOX AOM701

[. . . ] While it will withstand short periods of exposure to moisture, this product does contain sensitive electronic components and exposure to moisture should be limited by the user / installer. This product is not designed for applications where constant exposure to moisture or immersion can be encountered. This unit should NEVER be cleaned with a power washer or used where direct power washer spray may be encountered. 2 PA C K I NG C ONT E NT S: 90 DAY/ 12 MONT H LIMIT E D WAR R ANT Y WA R R A NT Y CA R D QT Y . 1 #8 X ¾" SE L F DR IL L B L A CK SCR E WS (HA R DWA R E B A G) QT Y . 4 POWE R HA R NE SS QT Y . [. . . ] A/B Input Select Button This control toggles the active display image back and forth between AV1 and AV2 inputs. Day/Night Mode Button This control toggles the unit between "Day" and "Night" LCD illumination modes. In the "Day" mode, the LCD backlight intensity is at maximum. In "Night" mode, the LCD backlight is dimmed to a preset level that is more suitable for low light operation. Picture Adjustment Menu Button This control accesses an On-Screen-Display (OSD) menu for four LCD picture adjustments (Brightness, Contrast, Color, and Tint). The first depress of the button accesses the "Brightness" adjustment. The Volume +/- controls adjust the level, which is indicated by the bar graph at the bottom of the screen. Each consecutive depress of the Picture button accesses the adjustment screen for each picture adjustment. If no buttons are pressed within 6 seconds or controls other than the Picture and Volume buttons are pressed, the unit will exit the Picture Adjustment mode. ­ + 5. Volume +/- Buttons This 2-button set of controls adjusts the output volume of the built-in audio speaker when the audio function is enabled *(see typical system connection diagram). Volume level is indicated by the OSD bar graph at the bottom of the screen. These buttons also serve as adjustment controls while in the Picture Adjustment Menu mode (see above section for details). *Note: The AOM701 requires +12V to be applied to the "Audio Enable" trigger input in order to activate the built-in speaker. If no audio output is heard from the speaker regardless of the volume level adjustment, check this connection. 5 INSTALLATION INSTRUCTIONS BEFORE YOU BEGIN INSTALLATION: Before drilling, be sure that no cable or wiring is on the other side. Clamp all wires securely to reduce the possibility of them being damaged during installation and use. Keep all cables away from hot or moving parts, and electrically noisy components. Wiring Definitions: ¡ Power connection: Pin 1 Pin 2 Pin 3 Pin 4 ACC +12V (Red) Standby Trigger (Blue wire) Ground (Black wire) Audio Trigger (Blue w/white stripe wire) ¡ ¡ ¡ Camera A input: Camera B input: LCD panel: Connection for camera or camera extension cable Connection for camera or camera extension cable 12-pin DIN cable connection. Procedure: 1. A ¾" (19mm) hole should be drilled for passing cables through vehicle walls, barriers, etc. [. . . ] If more cable length is needed, additional 5' lengths of the intermediate cable can be purchased. (See the accessory list at the back of this manual for part number details. ) 6. Plug camera extension cable (available separately) into AV1or AV2 input connector on the connection cable. Make sure all cables are routed away from hot or moving parts, and away from sharp edges. [. . . ]