User manual ASUS WL-530G V2

[. . . ] Firmly insert the DIMM into the socket until the retaining clips snap back in place and the DIMM is properly seated. Follow steps 1-3 to install additional modules. Memory socket Retaining clips 2 Install the CPU and heatsink with fan Lever 1. Unlock the socket by pressing the level sideways, then lift it up to a 90º~100º angle. [. . . ] DO NOT force the CPU into the socket to prevent bending the pins and damaging the CPU. If the CPU does not fit, check its orientation or check for bent pins. When the CPU is in place, push down the socket lever to secure the CPU. (Refer to the documentation that came with the heatsink with fan and the motherboard user guide. ) 6. Connect the CPU fan power cable to the CPU fan connector on the motherboard. Socket CPU Small triangle Gold triangle Heatsink with fan 3 English English 3 Mount the motherboard Screws NOTE: The following procedure applies to most standard chassis. Before you install the motherboard, study the configuration of your chassis to ensure that the motherboard fits into it. 1. Screw the standoffs that came with your chassis into the appropriate screw holes on the chassis. Remove the temporary metal shield on the rear panel that covers the rear I/O slot opening. Make sure that your ATX 12V power supply can provide 8A on the +12V lead and at least 1A on the +5-volt standby lead (+5VSB). The system may become unstable or may not boot up if the power is inadequate. 20-pin connector 4-pin connector 9 Connect the peripherals and accessories Power strip PS/2 Mouse AC Keyboard PS/2 Parallel Printer Digital Speakers S/PDIF IEEE 1394 Mobile HDD PDA cradle Serial RJ-45 Switch Hub Storage device USB Line in Tape recorder Microphone Mic VGA CRT Monitor Speakers Line Out DVI Flat Panel Monitor 9 English English 10 Power Up Turn on the power of the monitor, peripherals and system. If necessary, format your hard disk drive and install an operating system. NOTE: If you encounter any BIOS related problems, enter the BIOS setup by pressing <Del> during startup. To restore all BIOS settings to the default value, press <F5> and select Yes. Troubleshooting If you encounter any of the following conditions when powering up the system, try performing one of the possible solutions before calling for technical support. CONDITIONS PC won't start up PC starts up, but no display POSSIBLE SOLUTIONS · Check the power cord and make sure it is connected properly. · Make sure that the monitor is turned ON and properly connected to the graphics port. · Check the brightness and contract controls of the monitor, make sure it is turned up. [. . . ] · Shutdown the computer, disconnect the power cord, and make sure the graphics card is inserted properly in its expansion slot. · Check the memory modules and make sure they are of the correct type. · Make sure that the memory modules are properly inserted into the sockets. [. . . ]