User manual ASUS V3-P5V900 V SERIES P5V900 USER’S MANUAL(ENGLISH)

[. . . ] If the voltage supply in your area is 100-127 V, set the switch to 115 V. If the voltage supply in your area is 200-240 V, set the switch to 230 V. NOTE: Refer to the system User Guide for the exact location of the voltage selector. Removing the side cover and front panel assembly 1. Pull the side cover toward the rear panel until its hooks disengage from the chassis tab holes. Locate the front panel assembly hooks, then lift them until they disengage from the chassis. [. . . ] Swing the front panel assembly to the right, until the hinge-like tabs on the right side of the assembly are exposed. Remove the front panel assembly, then set aside. 3 4 Air duct 1 2 1 3 3 4 4 2 Chassis tab holes 3 Installation manual Installing a CPU Installing an Intel® Pentium® 4 CPU in the LGA775 package 1. Press the load lever with your thumb (A), then move it to the left (B) until it is released from the retention tab. CAUTION. To prevent damage to the socket pins, do not remove the PnP cap unless you are installing a CPU. 4. Lift the load lever in the direction of the arrow to a 135º angle. Lift the load plate with your thumb and forefingertoa100ºangle(4A), thenpushthe PnP cap from the load plate window to remove (4B). 3 4B PnP cap Load plate 4A 5. Position the CPU over the socket, making sure that the gold triangle is on the bottom-left corner of the socket. Fit the socket alignment key into the CPU notch. Gold triangle mark Alignment key 6. Close the load plate (A), then push the load lever (B) until it snaps into the retention tab. A B Installation manual Installing an AMD CPU 1. Locate the CPU socket, then lift the socket lever to a 90º angle. Install the CPU to the socket, making sure that the CPU corner with the gold triangle matches the socket corner with a small triangle. Remove the metal cover opposite the slot that you intend to use. 1 2. Remove the metal bracket lock. 2 3. 4. Insert the card connector to the slot, thenpressthecardfirmly untilitfitsinplace. Replace the metal bracket lock. 4 3 Installation manual Installing storage drives Optical drive 1. Place the chassis upright, then remove the upper 5. 25" drive bay metal plate cover. Insert the optical drive to the bay, then carefully push the drive until its screw holes align with the holes on the bay. Connect the IDE (A) and power (B) plugs to connectors at the back of the drive. A 3 2 3 3. Place the chassis upright, then remove the lower 3. 5" drive bay metal plate cover. Insertthefloppydiskdrivetothe bay, then carefully push the drive until its screw holes align with the holes on the bay. Connect the signal (A) and power (B) plugs to connectors at the back of the drive. 3 2 3 3. [. . . ] Insertthefloppydiskdrivetothe bay, then carefully push the drive until its screw holes align with the holes on the bay. Connect the signal (A) and power (B) plugs to connectors at the back of the drive. 3 2 3 3. Place the chassis upright, then remove the upper 3. 5" drive bay metal plate cover. Insert the hard disk drive to the bay, then carefully push the drive until its screw holes align with the holes on the bay. [. . . ]