User manual ALERTEGPS G120

[. . . ] It features a speed limiter function, and an internal memory to save your own points of interest. Please read this manual carefully so that you can feel familiar with all functionalities of the G120. Have a good trip! CONTENTS DESCRIPTION INSTALLING THE G120 FEATURES UPDATE GENERAL NOTICES AND WARNINGS PAGE 2 PAGE 3 PAGE 4 - 5 PAGE 6 PAGE 7 Description & Features 3 2 1 2 Vol - / Save button Speed limiter 2 3 Vol Diodes External antenna connector 4 4 1 5 6 USB, cigar-plug and power supply connector PC connection and battery charging on cigar-plug or power supply. 5 6 OVERSPEED BEEP As you approach a fixed speed camera, the G300 will emit "beeps" if you are driving over the speed limit. INSTALLING THE G120 1 3 Remove the protection from the magnet 2 Fix the magnet on the dashboard of your vehicle, in a horizontal position and as close as possible to the windscreen Place the G120 on the magnet when you want to use it in your vehicle Connect the device to the cigarette-lighter with the power cable 3 4 Your vehicle may have an athermic windscreen which may affect the satellite connection. [. . . ] To cancel a POI: as you pass the point, and after the alert has started to sound, press the save button app. This can be done during 15 seconds after the beginning of the vocal alert. Update 6 To get the latest files for your G120 (fixed and mobile speed cameras, danger zones), please visit www. alertegps. com PC Installation 1 2 3 4 5 Update AUTO UPDATE Connect the G120 to your PC. Click on "Auto Update" 1 2 MANUAL UPDATE Please follow the indications about manual update available at : WWW. ALERTEGPS. COM DOWNLOAD SOFTWARE AND DRIVER FROM ALERTEGPS. COM INSTALL USB DRIVER (DON'T CONNECT THE G120 TO YOUR PC). CONNECT THE USB CABLE TO THE G120. LAUNCH APPLICATION AND FOLLOW INSTRUCTIONS HAVE PROBLEMS INSTALLING OR UPDATING YOUR G120?PLEASE HAVE A LOOK AT THE ONLINE INSTALLATION GUIDE AVAILABLE AT: HTTP://WWW. ALERTEGPS. COM To get the latest files for your G120 (fixed and mobile speed cameras, danger zones), please visit : http://www. alertegps. com General notices and Warnings Waste Electrical and Electronic Equipment Directive According to Directive 2002/96/EC on Waste Electrical and Electronic Equipment, household electrical appliances cannot be dispersed in the conventional waste stream. Used electrical and electronic equipments must be collected · If the unit or the cigar-plug falls in the water, don't touch the unit before you have disconnected the cigar-plug from the cigar socket of your vehicle, and remove the unit using the cable. · Read this manual and all safety warnings carefully before you use or install this unit. · If your vehicle is parked in the sun, let the unit cool down before you use it. · The G120 cannot work properly in a tunnel or a basement, because the satellite reception is disturbed. The G120 needs a short time to establish the connection to the satellites again. · The G120 calculates the direction of the vehicle to avoid wrong alerts. If you're driving a parallel road that is sited very close to a road on which an alert is located, a wrong alert may occur. · The G120 is a driving aid that must be considered as a prevention tool. The purpose of this system is to encourage you to drive carefully and to respect the road safety rules. We decline all responsibility for any infringement to the legislation and the road safety rules. · Hardware and software of this device are the property of GPS PREVENT and are protected by copyright laws and intellectual property laws. [. . . ] · Don't connect any cable to the unit before removing or connecting the power cable. Connect the external antenna after the power cable, and disconnect it before you remove the power cable. GPSprevent declines all responsibility in case of software or hardware incompatibility. [. . . ]