User manual ALCATEL BABY LINK 290 // ENGLISH

[. . . ] line jack CAUTION: Use only the power adapter (6Vac 300mA) that came with this unit. Contact your local distributor if you need to order replacement for the power adapter. Telephone base and handset layout Settings Ringer Volume You can select the handset ringer volume from four levels or turn the ringer off. Press UP to increase or DOWN to decrease the ringer volume when the handset is in idle mode. A beep sounds when the volume is adjusted to the maximum or minimum level. [. . . ] #/PAUSE: Press and hold to add a dialing pause when entering numbers into phonebook. Call waiting To use call waiting, you must subscribe to call waiting service from your telephone service provider. This feature allows you to receive calls while you are already on a call. You will hear a call waiting alert tone when there is a second incoming call. 2. Press FLASH to switch between calls. Mute When the mute feature is turned on, you can hear the other party, but the other party cannot hear you. Temporary tone dialing If you are using pulse (rotary) dialing service, you can temporarily switch from pulse to touch-tone dialing during a call. The telephone automatically returns to pulse dialing after you end the call. Troubleshooting guide If your telephone system is not operating properly, first try these general reset procedures: 1. nplug the power adapter from power outlet. U 2. isconnect the telephone line cord from the base or modular D jack. 3. emove the battery compartment covers and unplug all handset R batteries. Be sure not P to use outlets that are controlled by wall switches or timers. 6. lace the handset in the telephone base to charge without P interruption for at least 30 minutes before use. hen replacing battery(ies), all batteries should be replaced W at the same time. Mixing fresh and discharged batteries could increase internal cell pressure and rupture the discharged battery(ies). (Applies to products employing more than one separately replaceable primary battery. ) 10. When inserting battery(ies) into this product, the proper polarity or direction must be observed. Reverse insertion of battery(ies) may result in leakage or explosion. Environment Used equipment must be disposed of in compliance with current environmental protection regulations. You should return it to you retailer or dispose of it in an approved recycling center. Do not attempt to open the batteries as they contain chemical substances. In the event of contact, rinse the affected part for several minutes in running water. Clean the product with absorbent paper or a dry cloth and contact your retailer for replacement batteries. CAUTION WARNING: TO PREVENT FIRE OR ELECTRICAL SHOCK HAZARD, DO NOT EXPOSE THIS PRODUCT TO RAIN OR MOISTURE. RISK OF ELECTRICAL SHOCK, DO NOT OPEN Handset paging You can use the handset paging feature to find misplaced handset. Press the PAGE button at the back of the telephone base to start the paging tone on the handset for 30 seconds. Press any key on the handset or press the PAGE button again to stop the paging. NOTE: Paging tone sounds even when the ringer is turned off. Registering a handset The handset included in the package is pre-registered. To re-register a handset: 1. ress and hold */TONE on the handset until the light indicator P flashes. [. . . ] Do not place product upon other consumer electronic products such as; computer monitors, power amplifiers, etc. 14. Do not place lighted candles, cigarettes, cigars, etc. , on the telephone. 15. Never touch uninsulated telephone wires or terminals unless the telephone line has been disconnected at the network interface. 16. Never install or modify telephone wiring during a lightning 17. Never install telephone jacks in wet locations unless the jack is specifically designed for wet locations. [. . . ]