User manual AEG-ELECTROLUX LN73470

[. . . ] Deep fat fryers must be continuously monitored during use: overheated oil can burst into flames. Do not flambè under the range hood; risk of fire This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. [. . . ] EN - RECOMMENDATIONS AND SUGGESTIONS - The Instructions for Use apply to several versions of this appliance. Ty Product Components 11 Hood Canopy complete with: Controls, Lights, Filters 21 Telescopic chimney made up of: 2. Placethedrillingtemplate21 provided on the ceiling/support shelf, making sure that the template is in the correct position by lining up the axes of the template with those of the hob. Loosenthetwoscrewsfasteningthelowerchimney and remove this from the lower frame. Insert the upper chimney stack from above, and leave it running free on the frame. Lift up the frame, fit the frame slots onto the screws up to the slot end positions. Before tightening the screws completely it is possible to adjust the frame by turning it. Make sure that the screws do not come out of their seats in the slotted holes. p = Intensive Speed , timed for 5 minutes , after which the system returns to the previous speed. When the required speed is touched, it will become brighter (intensity 100%) than the other functions (intensity 50%). Touching this button activates automatic shutdown of the Motor, the Fans and the Lighting with a 10 minute delay. It can only be activated with the motor on, running at any speed except Intensive, and with the Sensor = Off. When this button is pressed and held for 4 seconds (Motor Off + Lights Off, in the absence of other alarms, the Led will light up for: 4 seconds to indicate that the Remote Control has been Activated 2 seconds to indicate that the Remote Control has been Deactivated In this mode the Hood operates automatically for a maximum of 5 hours, after which it switches the Motor off. The hood modifies the speed of the motor according to the findings of the sensor. When this area is touched, the Lights turn on at the required intensity. When the lighting intensity is touched, it will become brighter (intensity 100%) than the other functions (intensity 50%). [. . . ] When no commands are given for at least 10 seconds, only the selected functions will be lighted (Intensity 100%) and all the rest will turn off (Intensity 50%). After 7 hours in operation, if no further commands are given the hood will switch off (Motor Off + Lights Off), from here you can touch for activated the function, and the next touch you can select the desired function. It is possible to activate one of the hood functions (Speed and Lighting) not just by touching the control panel, but also by placing a finger on the panel and sliding it towards the chosen function without lifting it off. [. . . ]