User manual AEG-ELECTROLUX GA60GLI220

[. . . ] ⷠOnly use the appliance to clean accessories that are applicable for dishwashers. ⷠDo not put flammable products or items that are wet with flammable products in, near or on the appliance. Put the knives and all items with sharp points in the cutlery basket with their points down. If not, put in a horizontal position in the upper basket or in the knife basket. [. . . ] 1) When the salt container and/or the rinse aid dispenser are empty, the related indicators do not come on while a washing programme operates. After ten minutes from the end of the washing programme, the Auto Off function automatically deactivates the appliance. Delay start button Press this button again and again to delay the start of the washing programme from 1 to 24 hours. You cannot activate or deactivate the function while a washing programme operates. You cannot activate or deactivate the function while a washing programme operates. Half-load button Use this function when it is necessary to start a washing programme with a small load. the half-load function decreases the programme time and the consumption of water and energy. When you use this function, put the load in the two baskets and decrease the detergent quantity. activate or deactivate the half-load function before the start of a washing programme. You cannot activate or deactivate the function while a washing programme operates. Programme button Press this button again and again to set a washing programme. Each time you press the button, the display shows a number that is related to a washing programme. Function buttons With these buttons you can: · Setting mode The appliance must be in setting mode for these operations: · ­ It is necessary to cancel the programme or the delay start to go back to the setting mode. Be sure that the set level of the water softener agrees with the water hardness in your area. If you use the combi detergent tablets ('3 in 1', '4 in 1', '5 in 1'), use the multitab function (refer to 'Multitab function'). Adjust the level of the water softener if this does not agree with the water hardness in your area. Contact your local water authority to know the water hardness in your area. The display shows the setting of the = level water softener (example: 5). Fill the salt container with 1 litre of water (only for the first time you fill with salt). It is correct that water comes out from the salt container when you fill it with salt. These cannot fully dissolve with short washing programmes and can decrease the washing results. Use of rinse aid Rinse aid makes it possible to dry the dishes without streaks and stains. [. . . ] Make sure that an incorrect position of the items do not cause the blockage of the spray arms. Make sure that the filters are clean and correctly assembled and installed. There are streaks, whitish stains, or a bluish layer on glasses and dishes. The washing programme was without a drying phase or with a decreased drying phase. [. . . ]