User manual AEG-ELECTROLUX GA55GLI220

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual AEG-ELECTROLUX GA55GLI220. We hope that this AEG-ELECTROLUX GA55GLI220 user guide will be useful to you.


AEG-ELECTROLUX GA55GLI220 : Download the complete user guide (8141 Ko)

Manual abstract: user guide AEG-ELECTROLUX GA55GLI220

Detailed instructions for use are in the User's Guide.

[. . . ] Should the appliance power supply cable need to be replaced, this must be carried out by our Service Centre. €¢ Connect the mains plug to the mains socket only at the end of the installation. Make sure that there is access to the mains plug after the installation. €¢ Do not pull the mains cable to disconnect the appliance. [. . . ] Make sure that the salt container and the rinse aid dispenser are full. Start the shortest programme with a rinsing phase, without detergent and without dishes. 1 Energy Saver This option decreases the temperature in the last rinse phase. The use of this option decreases the energy consumption (up to 25%) and the programme duration. €¢ If the option is not applicable to the programme, the related indicator flashes quickly 3 times and then goes off. Make sure that the set level of the water softener agrees with the water hardness in your area. Contact your local water authority to know the water hardness in your area. Manual adjustment Turn the water hardness dial to the position 1 or 2. Make sure that the appliance is in setting mode, refer to “Setting and starting a programme”. Press and hold, at the same time, and until the indicators , and start to flash. The indicator • The display shows the current setting of the water softener, e. Press the on/off button to deactivate the appliance and to confirm the setting. Fill the rinse aid dispenser (A), no more than the mark 'max'. Remove the spilled rinse aid with an absorbent cloth to prevent too much foam. Make sure that the appliance is in setting mode, refer to ’Setting and starting a programme’. €¢ If the rinse aid indicator is on, fill the rinse aid dispenser. €¢ If you use the combi detergent tablets, activate the Multitab option. Set and start the correct programme for the type of load and the degree of soil. If the programme has a prewash phase, put a small quantity of detergent on the inner part of the appliance door. 2 Setting and starting a programme Setting mode For some settings it is necessary that the appliance is in setting mode. The appliance is in setting mode when all the programme indicators come on and the display shows 2 horizontal status bars. Press one of the programme buttons again and again until only the indicator of the programme you want to set is on. [. . . ] Press and hold, at the same time, and until the indicators , Rinse aid dispenser off. Press the on/off button to deactivate the appliance and to confirm the setting. 10 W 546 / 759 / 571 1) Connect the water inlet hose to a water tap with a 3/4'' thread. Solar panels, aeolian energy), use the hot water supply to decrease energy consumption. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE AEG-ELECTROLUX GA55GLI220




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual AEG-ELECTROLUX GA55GLI220 will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.