User manual AEG-ELECTROLUX EWF1286LEW

[. . . ] EN WASHING MACHINE USER MANUAL 2 www. electrolux. com CONTENTS 1. 21 WE’RE THINKING OF YOU Thank you for purchasing an Electrolux appliance. You’ve chosen a product that brings with it decades of professional experience and innovation. So whenever you use it, you can be safe in the knowledge that you’ll get great results every time. [. . . ] • To activate/deactivate this option press and at the same time until the indicator comes on/goes off. 7. 7 Time Manager When you set a washing programme, the display shows the default duration. The Time Manager is available only with the programmes in the table. 7. 10 Acoustic signals The acoustic signals operate when: • The programme is completed. • The appliance has a malfunction. ENGLISH 11 To deactivate/activate the acoustic signals, press and at the same time for 6 seconds. If you deactivate the acoustic signals, they continue operate when the appliance has a malfunction. 8. BEFORE FIRST USE 1. 2. Put 2 litre of water in the detergent compartment for washing phase. Put a small quantity of detergent in the compartment for washing phase. 3. Set and start a programme for cotton at the highest temperature without laundry. There is a risk of water leakage or damage to the laundry. 9. 2 Using detergent and additives • Measure out the detergent and the fabric conditioner. • Carefully close the detergent drawer. Detergent compartment for prewash phase. Detergent compartment for washing phase. 12 www. electrolux. com Compartment for liquid additives (fabric conditioner, starch). Flap for powder or liquid detergent. Liquid or powder detergent 1. 2. A 3. 4. B • Position A for powder detergent (factory setting). When you use the liquid detergent: – Do not use gelatinous or thick liquid detergents. – Do not set the delay start. 9. 3 Activating the appliance Press the Marche/Arrêt button to activate or deactivate the appliance. A tune sounds when the appliance is activated. 9. 4 Setting a programme 1. 2. Turn the programme knob and set the programme: – The related programme indicator comes on. flashes. – The indicator of the – The display shows the level of the Time Manager, the programme duration and the indicators of the programme phases If necessary, change the temperature, the spin speed, the cycle duration, or add available options. When you activate an option, the indicator of the set option comes on. ENGLISH 13 If you set something incorrect, the display shows the message Err. 9. 5 Starting a programme without delay start Press : • The indicator stops to flash and stays on. • The programme starts, the door is locked and the display shows the indi. cator • The drain pump can operate for a short time when the appliance fills water. After approximately 15 minutes from the start of the programme: • The appliance adjusts automatically the programme duration agree with the laundry load. The programme continues. 9. 8 Cancelling a programme 1. 2. Press the button for some seconds to cancel the programme and to deactivate the appliance. The appliance does not drain the water. 9. 9 Opening the door While a programme or the delay start operates, the appliance door is locked and . If the temperature and level of the water in the drum are too high, you cannot open the door. 4. 9. 6 Starting a programme with delay start • Press again and again until the display shows the delay you want to set. [. . . ] When you drain the water with the emergency drain procedure, you must activate again the drain system: 1. Put 2 litres of water in the main wash compartment of the detergent dispenser. 2. Start the programme to drain the water. 11. 9 Frost precautions If the appliance is installed in an area where the temperature can be less than 0° C, remove the remaining water from the inlet hose and the drain pump. 6. Put the two ends of the inlet hose in a container and let the water flow out of the hose. When the drain pump is empty, install the inlet hose again. WARNING! [. . . ]