User manual AEG-ELECTROLUX ESL64052

[. . . ] If you are unsure about any aspect of the information in this book, please contact our customer care department on 08705 950 950 q Under no circumstances should you attempt to repair the Installation machine yourself. Repairs carried out by inexperienced q Check your dishwasher for any transport damage. q For safety reasons it is dangerous to alter the specifications or attempt to modify this product in any way. q Any electrical and plumbing work required to install this appliance should be carried out by a qualified and competent person. Care must be taken to ensure that the appliance does not stand on the electrical supply cable. [. . . ] In this case the salt and the rinse aid indicator lights will always remain illuminated when the machine is switched on (not all dishwasher models are foreseen with salt and rinse aid indicator lights). Before the start of the washing programme put the "3 in 1" detergent in the detergent dispenser. NOTE: If the drying results are not satisfactory we recommend that you: 1. Set the rinse aid dosage to position 2. Concentrated detergent Modern detergents for dishwashers are almost exclusively lowalkaline concentrated detergents with natural enzymes in tablet form. Using 50°C washing programmes in conjunction with these concentrated detergents reduces pollution and is good for your dishes, as these washing programmes are specially matched to the dirt-dissolving properties of the enzymes in concentrated detergents. It is for this reason that using 50°C washing programmes in conjunction with concentrated detergents can achieve the same cleaning results that can otherwise only be achieved using 65°C washing programmes. If you decide to turn back to the use of the standard detergent system we advise that you: q q Fill up the dispensers for salt and rinse aid again. Adjust the water hardness setting to the highest setting perform up to 3 normal washing programmes without loading any dishes. Adjust the water hardness setting according to the hardness of the water in your area. Adjust the rinse aid dosage. q q NOTE: When using 4 in 1 detergents that integrate also antiglass corrosion agent into "3 in 1" formula, please follow the same instruction as given for "3 in 1" detergents above. POURING EASY PACK TION DOUBLE AC FOR A BRILLIANT SHINE N EW LIQUID GEL POWDER RINSE C O N C E N T R AT E D D I S H WA S H E R D E T E R G E N T 10 Washing programmes Programme Degree of soil and type of load Cycle description (3) Consumption values Programme duration (in minutes) Energy consumption (in kWh) Water consumption (in litres) Intensive 70°C Heavy soil. Crockery, cutlery, pots and pans Hot prewash Main wash up to 70°C 2 warm rinses 1 hot rinse Drying Cold prewash Main wash up to 65°C 2 warm rinses 1 hot rinse Drying Main wash up to 65°C 1 hot rinse Cold prewash Main wash up to 50°C 1 cold rinse 1 hot rinse Drying 1 cold rinse (to avoid food scraps from sticking together). This programme does not require the use of detergent. 85 - 95 1, 7 - 1, 9 23 - 25 Normal 65°C Normal soil. Water may appear on the sides and the door of the dishwasher as the stainless steel will eventually become cooler than the dishes. When the washing programme has finished, it is recommended that the dishwasher is unplugged and the water tap turned off. To cancel a "delay start" in progress Open the dishwasher's door and press the delay start button, the corresponding indicator light turns off. NOTE: the start of the washing programme or the countdown of the delay start will occur only after the closure of the door. To interrupt or cancel a washing programme in progress Interrupt or cancel a washing programme in progress ONLY if it's absolutely necessary. Open the door carefully. To interrupt a washing programme in progress Open the dishwasher's door; the programme will stop. Close the door; the programme will start from the point at which it was interrupted. To cancel a washing programme in progress Open the dishwasher's door. Press the programme selection/cancel button for about 3 seconds, until the indicator light of the running programme turns off and the end of programme indicator light flashes, indicating that the running programme has been cancelled and that the machine has returned to setting mode. 12 Maintenance and cleaning Clean the external surfaces of the machine and control panel with a damp soft cloth. Never use abrasive products, scouring pads or solvent (acetone, trichloroethylene etc. . . . ). Ensure that the seals around the door, the detergent and rinse aid dispensers are cleaned regularly with a damp cloth. We recommend every 3 months to run a 65°C wash programme without dishes using detergent. Attention! Under no circumstances may the dishwasher be used without filters. [. . . ] If the door does not close correctly, loosen or tighten the adjustable feet until the machine is perfectly level. Fixing to the adjacent units The dishwasher must be secured against tilting. Therefore make sure that the counter it is fixed under, is suitably secured to a fixed structure (adjacent kitchen units cabinets, wall). 18 Water outlet hose connection The end of the drain hose can be connected in the following ways: 1. To the sink outlet spigot, securing it to the underside of the work surface. To a stand pipe provided with vent-hole, minimum internal diameter 4 cm. [. . . ]