User manual AEG-ELECTROLUX ESF6510LJX

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual AEG-ELECTROLUX ESF6510LJX. We hope that this AEG-ELECTROLUX ESF6510LJX user guide will be useful to you.


AEG-ELECTROLUX ESF6510LJX : Download the complete user guide (8568 Ko)

Manual abstract: user guide AEG-ELECTROLUX ESF6510LJX

Detailed instructions for use are in the User's Guide.

[. . . ] Partial load (to be completed later in the day). B 30 g / Rinse and Hold C On/Off / / * Testing programme for EN 50242. ** This is a special programme for quick washing a full load of lightly soiled dishes, glasses and crockery (except pots) so that you may re-use them promptly. Operating sequence 1. Check the filters Ensure that they are clean and properly positioned. (See "Maintenance and cleaning" - Instruction book part 1) 8. [. . . ] If you wish to interrupt the washing programme at any time press this button again. 2. Check that there is rinse aid and salt (See "Instruction book" - part 1) 3. Pull the lower basket out and arrange the saucepans, plates and cutlery in it. Pull the upper basket out and arrange the plates, saucers, glasses and cups etc. At the end of the washing programme At the end of the programme the dishwasher will automatically stop. The On/Off indicator light remains on until the On/Off push button is depressed. 10. Switch off the dishwasher Switch off the dishwasher by pressing the On/Off push button. Open the door and wait a few minutes before removing the dishes; in this way they will be cooler and the drying will be improved. Empty the lower basket first and then the upper one; this will avoid water dripping from the upper basket onto the dishes in the lower one. If the handles protrude from the bottom of the basket, obstructing the lower spray arm, load the cutlery with the handles facing upwards. For best results we recommend to use the cutlery grid provided (if the size and the dimensions of the cutlery allow it). If washing very large plates (over 27 cm and up to 32 cm in diameter) you can load them in the lower basket after moving the upper basket to the higher position. Move the front runner stops (A) of the upper basket outward and slide the basket out. Refit the basket in the higher position and replace the stops (A) in their original position. RC01 A When the top basket is in the higher position it will only take plates up to 20 cm in diameter and you will not be able to use the cup racks. After loading your machine always close the door, as an open door can be a hazard. 9 Hints for test centres Before starting any test it is necessary to fill completely with salt the salt container and with rinse aid the rinse aid dispenser. Test standard: Reference programme: Load: Rinse aid selector: Detergent dosage: EN 50242 Bio 50°C 12 standard place settings position 5 25 g in the dispenser 5 g on the dispenser lid Arrangement upper basket Arrangement lower basket Arrangement cutlery basket Technical specifications Dimensions Width Height with worktop Height without worktop Max depth Max depth with open door Voltage 60 cm 85 cm 82 cm 63. 5 cm 115. 2 cm 230 V - 50 Hz 200 W 2100 W 2300 W 50 kPa (0. 5 bar) 800 kPa (8 bar) max. 60°C 12 place settings 10 Electrical connection Motor rating during wash Power of heating element Overall power Water supply pressure Water supply connection Capacity Minimum Maximum Water cold/hot Fitting under a counter (kitchen worktop or sink) By removing the machine's worktop, you can install it under a close fitting sink unit or a pre-existing top, providing the dimensions of the recess correspond to those shown in the picture. 570 - 600 600 IN05 Proceed as follows: - Remove the machine's worktop by unscrewing the two rear retaining screws, pull from the front and slide out the rear slots, lifting the worktop. Insert the machine after adjusting height and levelling with the adjustable feet. When inserting the machine, ensure that the water inlet and drain hoses are not kinked or squashed. Levelling Good levelling is essential for correct closure and sealing of the door. When the appliance is correctly levelled, the door will not catch on the levelling spacers on either side of the cabinet. [. . . ] When the appliance is correctly levelled, the door will not catch on the levelling spacers on either side of the cabinet. If the door does not close correctly, loosen or tighten the adjustable feet until the machine is perfectly level. Protection against flooding In order to prevent water floods, the machine has been provided with an additional device in the bottom of the machine to protect against flooding. The device will operate if there are any water leaks in the machine, however it will only operate if the machine is on. In case of malfunction to repair the dishwasher, turn off the water tap and call the Service Force Centre. The products In order to obtain a good wash, it is necessary to use detergents specially designed for dishwashers. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE AEG-ELECTROLUX ESF6510LJX




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual AEG-ELECTROLUX ESF6510LJX will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.