User manual AEG-ELECTROLUX EFP6426/XS

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual AEG-ELECTROLUX EFP6426/XS. We hope that this AEG-ELECTROLUX EFP6426/XS user guide will be useful to you.


AEG-ELECTROLUX EFP6426/XS : Download the complete user guide (240 Ko)

Manual abstract: user guide AEG-ELECTROLUX EFP6426/XS

Detailed instructions for use are in the User's Guide.

[. . . ] · Since the rule for rooms with fuel burning appliances is "outlet hole of the same size as the ventilation hole", a hole of 500-600 cm2, which is to say a larger hole, could reduce the performance of the extractor hood. · If the hood is used in its filtering function, it will operate simply and safely in the above conditions without the need for any of the aforementioned measures. 30 · When the hood is used in its extractor function, the following rules must be followed to obtain optimal operation: -- short and straight outlet hose -- keep bends in outlet hose to a minimum -- never install the hoses with an acute angle, they must always follow a gentle curve only -- keep the hose as large as possible (preferably the same diameter as the outlet hole). · Failure to observe these basic instructions will drastically reduce the performance and increase the noise levels of the extractor hood. for the user · Always cover lighted elements, to prevent excess heat from damaging the appliance. [. . . ] · It is very important to clean the hood and replace the filter at the recommended intervals. Failure to do so could cause grease deposits to build up, resulting in a fire hazard. Introduction · The hood is supplied as an extractor unit and can also be used with a filtering function by fitting one charcoal filter (special accessory). · You will need original AEG charcoal filter KLF 60/80 for this function (see Special Accessories). Extractor version · In this version fumes are extracted to the outside via a hose. Filter Version · The air is filtered through a charcoal filter and returned to the kitchen. · You will need an original AEG KLF60/80 charcoal filter for the filtering function. 1 A = Switches (Motor, light) B = Grease filter C = Light D = Control panel E = Vapour catcher (Extractible) 31 Control Panel · The switches are arranged on the upper right side of the vapour catcher. 2 - from left to right): 1 2 3 4 = = = = = = = blower set 1 blower set 2 blower set 3 blower set 4 light light OFF light ON The blower is controlled by shifting the sliding switch. The extractor part (vapour catcher) of the hood is used to switch the blower on and off when the appliance is switched on (Motor). When the vapour catcher of the appliance is withdrawn (without preceding disengagement of the hood via the switches), the set fan output is automatically re-engaged. If the extractor part is re-inserted without operation of the switches, first the blower is switched off. The lighting can be separately switched on and off with the sliding switch. Turn the hood on a few minutes before you start cooking then you will get an underpressure in the kitchen. This information is shown on the registration plate located on the inside of the unit. · The charcoal filter can be ordered from the AEG technical assistance service. Fig. 4 Changing the light bulb(s) · Disconnect the unit from the mains power supply. · Replace the old light bulb with a new light bulb of the same kind. · If the light does not come on, make sure the bulb has been screwed in correctly before contacting the technical assistance service. CLOSED CLOSED OPEN OPEN Fig. 5 34 Technical Specifications Dimensions (in cm) Height Width Depth Lighting: Grease filter Maximum absorbed power 39, 5 59, 8 27, 5 + Lichtblende (max. 430 + Lichtblende) 2 x 40 W (E14) 2 320 W We reserve the right to generate constructive and chromatic modifications as required by technological growth. Special accessories Charcoal filter KLF 60/80 E-Nr. 610 899 421 Installation Unpacking Check that the cooker hood has no damages. Transportation damages should immediately be reported to the one responsible for the transport Damages, faults and eventually missing details should immediately be reported to the seller. Take care of the packing material so that small children cannot play with it. Min 75 cm Min 43 cm Placement The hood is to be mounted on the wall. 6 Electrical connection Safety warnings for the electrician Before connecting the appliance to the power supply, check that the voltage indicated on the rating plate corresponds to the mains power supply available. [. . . ] The manufacture declines all responsibility for malfunctions resulting from failure to comply with the above instructions. If the power socket is applied directly above the hood this gives two advantages: 1. the appliance can be disconnected at need merely be removing the plug. Electrical connection 220-240 V ­ by means of fixed power cable with plug. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE AEG-ELECTROLUX EFP6426/XS




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual AEG-ELECTROLUX EFP6426/XS will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.