User manual AEG-ELECTROLUX EFP630

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual AEG-ELECTROLUX EFP630. We hope that this AEG-ELECTROLUX EFP630 user guide will be useful to you.


AEG-ELECTROLUX EFP630 : Download the complete user guide (270 Ko)

You may also download the following manuals related to this product:

   AEG-ELECTROLUX EFP630 (1569 ko)

Manual abstract: user guide AEG-ELECTROLUX EFP630

Detailed instructions for use are in the User's Guide.

[. . . ] · If the room where the hood is to be used contains a fuel burning appliance such as a central heating boiler then its flue must be of the room sealed or balanced flue type. · If other types of flue or appliances are fitted ensure that there is an adequate supply of air to the room. · The ducting system for this appliance must not be connected to any existing ventilation system which is being used for any other purpose. Child Safety · This appliance is designed to be operated by adults. Children should not be allowed to tamper with the controls or play with the appliance. [. . . ] The metal grease filters can be machine washed in a dishwasher, or hand washed in hot water and a mild detergent or liquid soap. To Remove/Replace the Metal Filters Pull out the sliding suction panel. Remove the filters one by one, after having disconnected the relative fastening elements. (The colour of the filter surface may change throughout the time but this has no influence to the filter efficiency). When refitting the filters, make sure that the handle is visible on the outside. This appliance is a possible fire hazard if the grease filters are not cleaned reguarly and the charcoal filters replaced as recommended. EN · · · · · MAINTENANCE AND CLEANING electrolux 9 Changing the Light Bulb 9 W fluorescent lights. Lower the unfastened part of the glass cover slightly, so that the cover can be completely removed. · Replace the light with a new one of the same type and rating. Replacement filters and lamps can be obtained from your local Service Force Centre. EN 10 electrolux SOMETHING NOT WORKING SOMETHING NOT WORKING If, having followed these instructions carefully, your cooker hood fails to work properly please carry out the following checks. EN Symptom The cooker hood will not start Solution · Check the hood is connected to the electricity supply. · The fan speed is set high enough for the task · The grease filter is clean. For your own safety this should be undertaken by a qualified electrician e. g. your local Electricity Board, or a contractor who is on the roll of the National Inspection Council for Electrical Installation Contracting (NICEIC). Electrical Connection Before connecting to the mains supply ensure that the mains voltage corresponds to the voltage on the rating plate inside the cooker hood. This appliance is fitted with a 3 core mains cable and must be permanently connected to the electricity supply via a double-pole switch having 3mm minimum contact gap on each pole. A Switched Fuse Connection Unit to BS1363 Part 4, fitted with a 3 Amp fuse, is a recommended mains supply connection accessory to ensure compliance with the Safety Requirements applicable to fixed wiring instructions. 78 308 regarding suppression of radio and television interference. EN 16 electrolux INSTALLING THE COOKER HOOD INSTALLING THE COOKER HOOD Please ensure that when the appliance is installed it is easily accessible to an engineer in the EN event of a breakdown. All installations must comply with the local authorities requirements for the discharge of exhaust air. Installation Requirements Before fitting the hood beneath any type of canopy or wall cabinet, ensure that the housing is firmly fixed to the wall in accordance with the manufacturer's instructions. If it is necessary to fix the housing for the canopy to a hollow construction plaster or partition board structure then it should be sufficiently reinforced to be quite rigid in the area of the cabinet housing fixings. Ducting The ducting must be fire retardant 125mm (5ins) in diameter and the length should be no more than: 3 metres with one 90° bend 2 metres with two 90° bends Bends of more than 90° will reduce the efficiency of the hood and reduce the airflow. Clearance Height The cooker hood is designed to be fitted over a cooking appliance at the clearance heights stated, providing the maximum output of the appliance beneath does not exceed the maximums quoted in the Technical Specifications. If the output of the appliance below the cooker hood exceeds the maximum outputs quoted, please refer to the cooker manufacturer's installation instructions. [. . . ] Ensure that the activated charcoal filters have been inserted. · · · 12e 8 · · · INSTALLING THE COOKER HOOD electrolux 21 Extraction The charcoal filters are not required in this mode and should be removed. To do this reverse the procedure described in Inserting the `Charcoal Filters'. Ducting EN The ducting used must be fire retardant 125mm (5") in diameter. If possible duct through the wall at the rear of the canopy or wall cabinet. For the best performance use the shortest possible duct run and the minimum number of bends. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE AEG-ELECTROLUX EFP630




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual AEG-ELECTROLUX EFP630 will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.