User manual ADE OPTIMA XM

[. . . ] Enteryour code number. Check that the system is clear (none of the zone indicators are showing]. If clear, the sounder will produce a bleep tone and you may now leave by the approved route. [. . . ] If you omit zones and require quick Set, press SET twice. POWER INDICATOR A red Power indicator should be showing on the control panel at all times. If this Enter your code, if the system is clear (no alarm has been activated) thesystem will return to Day. If the system has been activated, then entering the code will turn off the alarm and cause the condition to be displayed. Press RESET to clear the indication and return to Day. T OMIT A ZONE O indicator goes out, the mains supply has failed or been disconnected. If in doubt call the engineer for assistance. FAULTS/PROBLEMS Starting from the Day mode, enter your code and the exit tone will start. The zone 2 and 4 indicators will now be displayed. It is importantto have your alarm system checked and tested regularly to ensure correct operation. It is also advisable to have a maintenance contract or agreement with the alarm installation company. If any faults occur, or any fault indicators remain on the display and cannot be cleared, call the engineer. Fill in the details below, to help keep a record of your alarm system. [. . . ] The system will bleep and D Y and A T M E indicatorswill A PR T enter walk test. [. . . ]